Find the amount og work done

Solids cannot diffuse.

Answer:

F = m g sin theta      force accelerating block

m a = m g sin theta

a = 9.8 sin 24 = 3.99 m/sec^2

Light energy is part of a larger form of energy known as electromagnetic energy. Details about electromagnetic energy can be found below.

Electromagnetic spectrum is the entire range of wavelengths of all known electromagnetic radiations extending from gamma rays through visible light, infrared, and radio waves, to X-rays.

Visible light is the part of the electromagnetic spectrum, between infrared and ultraviolet, that is visible to the human eye.

Therefore, Light energy is part of a larger form of energy known as electromagnetic energy.

Learn more about electromagnetic spectrum at: https://brainly.com/question/23727978

#SPJ1

Answer:

yes sir

Explanation:

Answer:b

Explanation:

Answer:

ΔE[tex]_{int[/tex],₁ = 977.7 J , Q₁ = 977.7 J and W₁ = 0 J

Explanation:

Given the data in the question;

T[tex]_i[/tex] = 300 K, T[tex]_f[/tex] = 412 K, n = 0.7 mol

since helium is monoatomic;

Cv = (3/2)R, Cp = (5/2)R

W₁ = 0 J [ at constant volume or ΔV = 0]

Now for the first cylinder; from the first law of thermodynamics;

Q₁ = ΔE[tex]_{int[/tex],₁ +  W₁

Q₁ = ΔE[tex]_{int[/tex],₁ = n × Cv × ΔT

we substitute  

Q₁ = ΔE[tex]_{int[/tex],₁ = 0.7 × ( 3/2 )8.314 × ( 412 - 300 )

Q₁ = ΔE[tex]_{int[/tex],₁ = 0.7 × 12.471 × 112

Q₁ = ΔE[tex]_{int[/tex],₁ = 977.7 J

Therefore, ΔE[tex]_{int[/tex],₁ = 977.7 J , Q₁ = 977.7 J and W₁ = 0 J

Relative density is the ratio of the density of a substance to the density of a given material.

Answer:

because the mass of the apple is very less compared to the mass of earth. Due to less mass the apple cannot produce noticable acceleration in the earth but the earth which has more mass produces noticable acceleration in the apple. thus we can see apple falling on towards the earth but we cannot see earth moving towards the apple.

Answer: The total rate of heat transfer from the container to its surroundings ignoring radiation is 332.67 W.

Explanation:

Given: Inner diameter = 0.9 m

q = 872 [tex]W/m^{3}[/tex]

Now, radii is calculated as follows.

[tex]r = \frac{diameter}{2}\\= \frac{0.9}{2}\\= 0.45 m[/tex]

Hence, the rate of heat transfer is as follows.

[tex]Q = q \times V[/tex]

where,

V = volume of sphere = [tex]\frac{4}{3} \pi r^{3}[/tex]

Substitute the values into above formula as follows.

[tex]Q = q \times \frac{4}{3} \pi r^{3}\\= 872 W/m^{3} \times \frac{4}{3} \times 3.14 \times (0.45 m)^{3}\\= 332.67 W[/tex]

Thus, we can conclude that the total rate of heat transfer from the container to its surroundings ignoring radiation is 332.67 W.

[tex]E_0=1.5033×10^{-10}\:\text{J}[/tex]

Explanation:

The rest energy [tex]E_0[/tex] of a proton of mass [tex]m_p[/tex] is given by

[tex]E_0 = m_pc^2[/tex]

[tex]\:\:\:\:\:\:\:=(1.6726×10^{-27}\:\text{kg})(2.9979×10^8\:\text{m/s})^2[/tex]

[tex]\:\:\:\:\:\:\:=1.5033×10^{-10}\:\text{J}[/tex]

Answer:

Nonrenewable energy

Explanation:

Renewable energy is also known as clean energy and it can be defined as a type of energy that are generated through natural sources or technology-based processes that are replenished constantly. Some examples of these natural sources are water (hydropower), wind (wind energy), sun (solar power), geothermal, biomass, waves etc.

Basically, a renewable energy source is sustainable and as such can not be exhausted.

On the other hand, a non-renewable energy refers to an energy source such as fossil fuels that takes a very long time to be created or their creation happened long ago and isn't likely to happen again e.g uranium.

For example, fossil fuels such as coal, oil, and natural gas, come from deep inside the Earth where they formed over millions of years ago.

In this scenario, the kind of energy the newspaper sources are talking about is a nonrenewable energy source because they are capable of being exhausted in the not-so-distant future.

Answer:

Graph (c) would be created by a pendulum with the greatest amplitude.

Explanation:

The amplitude of a wave is the greatest displacement covered by an object. It refers to the maximum amount of displacement of a particle on the medium from its rest position. It is the distance from rest to crest.

Out of three graphs, the amplitude is greatest in graph 3 as the distance from rest is crest in this case is maximum. Hence, the correct option is (c).

Answer:

95.0 colomb

Explanation:

Make sure to understand the concept

Let the point where A is launched act as the origin, so that the horizontal positions at time t of the respective projectiles are

• A : x = (19.5 m/s) cos(30°) t

• B : x = 62.2 m + (19.5 m/s) cos(60°) t

These positions are the same at the moment one projectile is directly above the other, which happens for time t such that

(19.5 m/s) cos(30°) t = 62.2 m + (19.5 m/s) cos(60°) t

Solve for t :

(19.5 m/s) (cos(30°) - cos(60°)) t = 62.2 m

t = (62.2 m) / ((19.5 m/s) (cos(30°) - cos(60°))

t ≈ 8.71 s

[tex]\implies {\blue {\boxed {\boxed {\purple {\sf { \frac{1}{I} = \frac{R}{E} + \frac{r}{E} }}}}}}[/tex]

[tex]\large\mathfrak{{\pmb{\underline{\orange{Step-by-step\:explanation}}{\orange{:}}}}}[/tex]

[tex]I = \frac{ E}{ R + r} \\[/tex]

[tex] ➺\:\frac{I}{1} = \frac{E}{R + r} \\[/tex]

Since [tex]\frac{a}{b} = \frac{c}{d} [/tex] can be written as [tex]ad = bc[/tex], we have

[tex]➺ \: I \: (R + r) = E \times 1[/tex]

[tex]➺ \: \frac{1}{I} = \frac{R + r}{E} \\ [/tex]

[tex]➺ \: \frac{1}{I} = \frac{R}{E} + \frac{r}{E} \\ [/tex]

[tex]\boxed{ Hence\:proved. }[/tex]

[tex]\red{\large\qquad \qquad \underline{ \pmb{{ \mathbb{ \maltese \: \: Mystique35ヅ}}}}}[/tex]

Answer:

the rock speed is increased

A rock is initially at rest concerning the earth, but the speed of the rock will increase when it hits the ground.

The resistance to something rolling or moving over another solid object is called friction. Even though frictional forces can be helpful, like the traction needed to walk without slipping, they also present a considerable amount of resistance to motion. About 20% of the engine power in a car is used to combat frictional forces in the moving parts.

The primary cause of friction between metals appears to be the forces of attraction, also known as adhesion, between the contact zones of the surfaces, which are always microscopically unequal. Because of friction caused by the imperfections of the tougher surface rubbing up against the softer surface, these "welded" connections are sheared.

To know more about Friction :

https://brainly.com/question/13000653

#SPJ2

Answer:

Units. Torque has the dimension of force times distance, symbolically T−2L2M. Although those fundamental dimensions are the same as that for energy or work, official SI literature suggests using the unit newton metre (N⋅m) and never the joule. The unit newton metre is properly denoted N⋅m.

Dimension: M L2T−2

In SI base units: kg⋅m2⋅s−2

Other units: pound-force-feet, lbf⋅inch, ozf⋅in

Answer:

hope it is helpful to you

☆☆☆☆☆☆☆☆☆☆☆

Answer:

The voltage across 150 ohm resistor is 6 volts.

Explanation:

Given that,

Resistors having resistances 150 ohms and 300 ohms are in series. Their equivalent is :

R = 150 + 300

R = 450 ohms

Let I is the current in the circuit. Using Ohm's law,

V = IR

[tex]I=\dfrac{V}{R}\\\\I=\dfrac{18}{450}\\\\I=0.04\ A[/tex]

The current in series remains the same while potential divides. So,

[tex]V_1=IR_1\\\\V_1=0.04\times 150\\\\=6\ V[/tex]

So, the voltage across 150 ohm resistor is 6 volts.

Answer:

The mass of each object is 2kg and 3 kg.

Explanation:

Given that,

Gravitational force,[tex]F=1\times 10^{-8}\ N[/tex]

The distance between masses, d = 20 cm = 0.2 m

The total mass of the two objects, M + m = 5 kg

M = 5-m

The formula for the gravitational force is :

[tex]F=G\dfrac{Mm}{d^2}\\\\1\times 10^{-8}=6.67\times 10^{-11}\times \dfrac{(5-m)m}{(0.2)^2}\\\\\frac{1\times10^{-8}}{6.67\times10^{-11}}=\frac{(5-x)x}{(0.2)^{2}}\\\\\frac{1\times10^{-8}}{6.67\times10^{-11}}\cdot(0.2)^{2}\\\\5.99=(5-x)x\\\\x=2\ kg\ and\ 3 \ kg[/tex]

So, the mass of each object is 2kg and 3 kg.

Answer:

Explanation:

Speed= distance/time

Or time = distance/speed

According to your question

Speed=15m/s

and. Distance=1.2km. ,we must change kilometer in meter because given speed is in m/s

D= 1.2km = 1.2×1000m =1200meter

Time = distance/ speed

1200/15 =80second

Or. 1min and 20 sec will be your answer.

Answer:

Due to the applied filed the electrons move in a particular direction.

Explanation:

Initially when the switch is off, the free electrons move here and there in any random directions in the conductor with the random speeds called thermal velocity.  So, tat the net flow is almost zero.

When the battery is connected is switch is ON, the random motion of the electrons aligned in a particular direction due to the force applied by the electric filed, so the net flow is not zero it increases and thus the current flow.

Answer:

Yes, when an apple falls towards the earth, the apple gets accelerated and comes down due to the gravitational force of attraction used by the earth. The apple also exerts an equal and opposite force on the earth but the earth does not move because the mass of the apple is very small, due to which the gravitational force produces a large acceleration in it (a = F/m) but the mass of the earth is very large, the same gravitational force produces very small acceleration in the earth and we don't see the earth rising towards the apple.

Answer:

answer is 18.58 because

Answer:

My answer is d.25.1 because

Answer:

W/7

Explanation:

By principle of moments,

Sum of clockwise moment = sum of anticlockwise moment

Weight × 7d = W × d

Weight = W/7

Since the two children are in rotational equilibrium, the weight of the second child is W/7.

The weight of the second child can be determined from the principle of moments.

The principle of moments states that for a body in equilibrium, the sum of the clockwise moments and anticlockwise moments about a point is zero.

Let the weight of the second child be X

From the principle of moments:

W × d = 7×d × X

X = W/7

Therefore, the weight of the second child is W/7.

Learn more about principle of moments at: https://brainly.com/question/20298772

Answer:

elative magnitude of the two forces is the same and they are applied in a constant direction.

Explanation:

Newton's second law states that the sum of the forces is equal to the mass times the acceleration  

              ∑ F = m a

in this case there are two forces on the x axis

             F_applied - fr = 0

since they indicate that the velocity is constant, consequently

             F_applied = fr

the relative magnitude of the two forces is the same and they are applied in a constant direction.

Answer:

Hence the amount of heat transfer is 918.75 Btu.

Explanation:

Now,

Answer:

Acceleration

Explanation:

The fact that new can go from zero to 60mph in 8 secs is a description of its pick-up or in physics,  it's called acceleration.

Here initial velocity u= 0

final velocity v = 60 mph = 1m/minute.

or v =1609.344/60 = 26.82m/s

and time taken to do so is 8 sec

Acceleration a = (v-u)/t

a = (26.82-0)/8 = 3.35 m/s^2

Therefore, acceleration of the car a = 3.35 m/s^2.

Answer:

D

Explanation:

This is a great way to manage health.

A would be avoiding everything which isnt good.

B. would be emotionally draining and damaging to bottle feelings and ignore them.

C. is unhealthy to not exercise and eat food while doing nothing.