Fluorescent light bulbs, or CFLs, prevent the loss of energy from light bulbs as ________ energy.
A. Light
B. Electrical
C. Chemical
D. Thermal

Answer:

Zinc weighs 65.38 grams per mole, so we’ve got 0.994 moles of zinc (I’ll worry about sig figs at the end). HCl weighs 36.46 grams per mile, so we’ve got 1.78 moles of HCl. However, two moles of HCl react with one mole of zinc. So only 1.78/2 = 0.890 moles of Zinc are going to react.

One mole of zinc produces one mole of hydrogen, which weigh 2.02 grams per mole. So 0.890 moles * 2.02 grams/mole means 1.90 grams of hydrogen will be produced.

Since we have 2 sig figs in the weights given, the answer should have 2 sig figs, thus 1.9 grams.

This is just an example

Answer:

(a) [tex]\Delta H=-73.1\frac{kJ}{mol}[/tex]

(b) [tex]T_2=38.1\°C[/tex]

(c) Yes, it is appropriated.

Explanation:

Hello.

(a) In this case, given the formation enthalpies for copper (II) sulfate, copper (II) ion and sulfate ion, we can compute the enthalpy change for such process as follows:

[tex]\Delta H=\Delta H_{Cu^{2+}}+\Delta H_{SO_4^{-2}}-\Delta H_{CuSO_4}\\\\\Delta H=64.8-909.3-(-771.4)\\\\\Delta H=-73.1\frac{kJ}{mol}[/tex]

(b) In this case, since 13.0 g of copper (II) sulfate (molar mass: 159.55 g/mol) we can compute the gained heat by water via:

[tex]Q_{water}=-n_{CuSO_4}\Delta H=-13.0g*\frac{1mol}{159.55g}* -73.1\frac{kJ}{mol}\\ \\Q_{water}=5.96kJ=5960J[/tex]

As the heat lost by the reaction is gained by the water, therefore, the final temperature is:

[tex]Q_{water}=m_{water}Cp_{water}(T_2-T_1)\\\\T_2=T_1+\frac{Q_{water}}{m_{water}Cp_{water}}\\ \\T_2=25.0\°C+\frac{5960J}{0.109L*\frac{1000g}{1L}*4.18\frac{J}{g\°C} } \\\\T_2=38.1\°C[/tex]

(c) In this case, since this dissolution reaction is exothermic as it increases the temperature when undergone, we can infer that yes, this dissolution would be appropriate for the preparation of a hot pack, because a cold pack would be with an endothermic dissolution reaction.

Best regards.

Answer:

batteries

Explanation:

bc they're powered by energy

Answer:

• the warmth from the sun

• the heat from another a heater

• A cup of hot chocolate

•baking in an oven

Two everyday example that we say for the thermal energy of a substance being increased are, faster movement of the substances and boiling if liquids as well light absorption.

Thermal energy is a form of energy generated by heating up a substance. It can also be generated by the movement of its particles.

Vibrating molecules increases the thermal energy of a substance. Similarly, when we heat a substance it acquires more thermal energy.

Another way of increasing thermal energy is light absorption by the substance. Thermal energy associated with light increases the temperature of of the system which is absorbed the light.

Hence, the two ways by which thermal energy of a substance is increased are heating or boiling and faster movement.

To learn more about thermal energy, refer the link below:

https://brainly.com/question/3022807

#SPJ2

Answer:

Control group

Answer:

Metalloids are brittle like Non-Metals

Explanation:

Answer:

YESBSJSKSSKEKEJRJRJER

Answer:

, containing 2.65 X 1020 molecules.

Explanation:

The mass of a sample of fruit sugar (fructose) C₆H₁₂O₆, containing 2.65 ×10²⁰ is equal to 2.88 g.

Avogadro’s number can be defined as the number of units in one mole of any chemical substance. Generally, these entities can be electrons, molecules, atoms, ions, or protons, depending upon the kind of chemical reaction or reactants and products.

The value of Avogadro’s constant is found approximately 6.022 × 10²³ mol⁻¹.

Given, the number of molecules of fructose = 2.65 ×10²⁰

The molar mass of the fructose = 180.16 g/mol

So 6.022 × 10²³ molecules of fructose have mass = 180.16 g

Then 2.65 × 10²⁰ fructose molecules will have mass = 2875.04 × 10⁻³ g

The mass of the  2.65 × 10²⁰ fructose molecules =  2.88 g

Therefore, the mass of  2.65 × 10²⁰ fructose molecules is equal to 2.88 g.

Learn more about Avogadro's number, here:

brainly.com/question/11907018

#SPJ2

Answer:

The answer is heterogeneous mixture

Answer:

An increase in the concentration of the reactant in solution causes the reaction rate to increase exponentially - first order

The reaction rate increases in direct proportion to the concentration of the reactant in solution -second order

The reaction rate is constant regardless of the amount of reactant in solution - zero order

Explanation:

The Order of Reaction refers to the power dependence of the rate on the concentration of each reactant. The order of reaction is determined experimentally and not necessarily by inspection.

Typically, in a second order reaction, the rate of reaction increases in proportion to increase in concentration.

For a first order reaction, the rate of reaction increases exponentially as the increase in concentration.

For a zero order reaction, the rate of reaction is independent of the concentration of the reactant.

Answer:

0.84 g/cm3 EDGE 2020

Explanation:

Answer:

What is the density of the football while it is deflated?

⇒ 0.84 g/cm3

Answer:

Helium has atomic mass  4.002602.

So the answer to yr question is helium.

There are various kind of elements that are present in periodic table. Elements that are metals are kept on left side of periodic table and elements which are non metals are kept on right side of periodic table.

Periodic table is a table in which we find elements with properties like metals, non metals and metalloids element arranges in increasing atomic number.

The first 20 elements of periodic table are Hydrogen, Helium, Lithium, Beryllium, Boron, Carbon, Nitrogen, Oxygen, Fluorine, Neon, Sodium, Magnesium, Aluminum, Silicon, Phosphorus, Sulfur, Chlorine, Argon, Potassium and Calcium. Out of these Lithium, Beryllium, Sodium, Magnesium. Potassium and Calcium are metals so they are kept on the left side of the periodic table while others are non metals so they are kept on right side of periodic table.

Learn more about periodic table, here:

https://brainly.com/question/11155928

#SPJ2

Answer:

alkali metals- Group 1

Explanation:

they have less valence electrons and therefore are more reactive

Answer : The correct option is A: 20 km/h, B: 10 km/h

Explanation :

Speed : It is defined as the distance traveled per unit time.

Formula used:

[tex]S=\frac{d}{t}[/tex]

where,

S = speed

d = distance

t = time

First we have to calculate the speed of vehicle A.

Given:

Distance of vehicle A = 50 km

Time of vehicle A = 2.5 hr

Now putting all the given values in the above formula, we get:

[tex]S=\frac{50km}{2.5hr}=20km/hr[/tex]

Now we have to calculate the speed of vehicle B.

Given:

Distance of vehicle B = 50 km

Time of vehicle B = 5 hr

Now putting all the given values in the above formula, we get:

[tex]S=\frac{50km}{5hr}=10km/hr[/tex]

Therefore, the speed of vehicle A and B is 20 km/hr and 10 km/hr respectively.

Answer:

Elements and compounds

Explanation:

Elements and compounds, mixtures are not chemically bonded and can be physically seperated

Answer:

Compact fluorescent lamps, or CFLs, use 75 percent less energy than a traditional incandescent bulb, but they never quite caught on for home use.Feb

Answer:

d. ii and iii

Explanation:

Both the Bohr model and the wave (quantum) mechanical  models of the atom recognize the principal quantum number n. The principal quantum number shows the shell or energy level where an electron may be found.

The energy levels are arranged in increasing order of magnitude. That is n=1 >n=2=n=3 etc

Answer:

d

Explanation:

d is the right answer since gases do not have definite shape and volume and liquids have definite volume. so liquid cannot change its volume but gas can

Answer:

Ksp = 8.99x10⁻¹²

Explanation:

The solubility of Mg(OH)₂ is described with the reaction:

Mg(OH)₂(s) → Mg²⁺(aq) + 2OH⁻(aq)

The solubility product, Ksp, is:

Ksp = [Mg²⁺] [OH⁻]²

As you can see from the reaction, when 1 mole of Mg²⁺ is produced, 2 moles of OH⁻ are produced too, if [Mg²⁺] is 1.31x10⁻⁴M, [OH⁻] = 2.62x10⁻⁴M

Replacing:

Ksp = [Mg²⁺] [OH⁻]²

Ksp = [1.31x10⁻⁴M] [2.62x10⁻⁴M]²

The solubility product of the [tex]\rm Mg(OH)_2[/tex] has been [tex]\rm 8.99\;\times\;10^{-12}[/tex].

The balanced equation for the dissociation of Magnesium hydroxide has been:

[tex]\rm Mg(OH)_2\;\rightarrow\;Mg^2^+\;+\;2\;OH^-[/tex]

From the balanced chemical equation, dissociation of 1 mole magnesium hydroxide has been resulted in the 1 mole magnesium and 2 mole hydroxide ions.

Since, given magnesium concentration, [tex]\rm Mg^2^+=1.31\;\times\;10^-^4\;M[/tex]

The concentration of hydroxide ion, [tex]\rm OH^-[/tex] will be:

[tex]\rm 1\;M\;Mg^2^+=2\;M\;OH^-\\1.31\;\times\;10^-^4\;M=1.31\;\times\;10^-^4\;\times\;2\;M\;OH^-\\1.31\;\times\;10^-^4\;M=2.62\;\times\;2\;M\;OH^-\\[/tex]

The solubility product (ksp) of the reaction has been given as:

[tex]ksp=\rm [Mg^2^+]\;[OH^-]^2[/tex]

Substituting the values for ksp:

[tex]ksp\;=\rm [1.31\;\times\;10^-^4]\;[2.62\;\times\;10^-^4]^2\\\textit ksp=8.99\;\times\;10^-^1^2[/tex]

The solubility product of the reaction has been [tex]\rm 8.99\;\times\;10^{-12}[/tex].

For more information about solubility product, refer to the link:

https://brainly.com/question/1163248

Answer:

A. cooling causes condensation

Explanation:

air is cooler at higher altitude in the troposphere.

Answer:

500g

Explanation:

Answer:Suppose that during the Icy Hot lab that 65 KJ of energy were transfered to 450 g of water at 20 degrees C. What would have been the final temerpatur

Explanation:

Answer:

the reactivity and the valence electrons

Explanation:

the reactivity of the elements would have played a significant role in why such elements were grouped together. the number of valence electrons dictates how reactive an element is - the less valence electrons the more reactive it is. the column, group 1 in which these elements are put together in, show that each of the elements have 1 valence electrons and are therefore reactive.

you can go on to further explain what valence electrons are, explain what the group numbers are associated with the valence electrons and how valence electrons effect reactivity. further this, talk about how the three elements have the same number of valence electrons and therefore were grouped together

Answer:

The reaction is at equilibrium.

Explanation:

In thermodynamics, the Gibbs free energy is a term used traditionally to refer to the available or  useful work that can be obtained from a thermodynamic system.

Gibbs free energy is a measure of the chemical potential that a reaction has left to do work. Hence, if the free energy is zero, then the reaction has attained equilibrium, and there is no more work to be done

The statement that should be true related to the reaction should be that it should be at equilibrium.

In terms of thermodynamics, this energy should be applied for the availability or the useful work that should be obtained via the system of thermodynamics.

Also, it determined the chemical potential where the reaction has left for doing the work. Also in the case when the free energy should be zero so here the reaction should be attained the equilibrium.

hence, the option b is correct.

Learn more about energy here:

Answer:

Um, I'd say add more types of plants cause different plants react differently to things, I guess?

Answer: conclusion

Explanation:

It say reviews your original question and your hypothesis

Answer:

conclusion!

Explanation: