Answer:
independent variable - the thing you change
dependent variable - the thing you measure
control variables - the things you keep the same
Question 1
Put these elements in order of the INCREASING the atomic radius.
Li, O, C, F
A)O, C, F, Li
B) Li, C, OF
C) F, O, C, Li
D) C, F, Li, o
Explanation:
we know that,
From Left to right (Period) atomic radius decreases
and
From Top to bottom (Group) atomic radius increases.
Li, C, O, F belongs to same period.
So,
Atomic radius decreases if we go left to right
Increasing order of Atomic radius -
Li > C > O > F
Therefore,
Option C is correct ✔.
Answer: C
Explanation:
What filters out liquid waste?
stomach
esophagus
kidneys
Answer:
kidneys
Explanation:
if you were conducting an experiment to see whether eating candy makes gerbils fat, what variable might you change?
A:The number of gerbils you feed incorrect answer
B:The amount of candy the gerbils eat incorrect answer
C:The amount of water the gerbils drink incorrect answer
D:The body mass of the gerbils incorrect answer
Answer:
B
Explanation:
the less candy will be the smallest gerbil and the most candy will be the fatest
Answer:
A) The number of gerbils you feed
Explanation:
If you wanted to test whether eating candy made gerbils fat you would need to fluctuate the amount of candy each group receives to observe whether there was any differnce in weight
A B C The circles shown above represent three different elements. The six images below are mixtures, how many of the images represent homogeneous mixtures.
edit; found the answer, since no one answered is: 2. for anyone wondering.
Answer: 2
Explanation:
What is the wavelength, in meters, of yellow light with a frequency of 5.10 x 1014 Hz?
Answer:
5.88 × 10⁻⁷ m
Explanation:
Speed of Light = Wavelength times Frequency
c = λν
Step 1: Define
c = 3.0 × 10⁸ m/s
ν = 5.10 × 10¹⁴ Hz
λ = unknown
Step 2: Solve for λ
3.0 × 10⁸ m/s = 5.10 × 10¹⁴ Hz · λ
λ = 5.88235 × 10⁻⁷ m
Step 3: Simplify
We are given 3 sig figs.
5.88235 × 10⁻⁷ m ≈ 5.88 × 10⁻⁷ m
A 30cm3 volume of water was placed in a cylinder, and a stone was dropped in. The water level rose by 35cm3. Is it true that the stone was 5cm3?
Answer:
The volume of stone is 5cm³.
Explanation:
Given data:
Volume of water = 30 cm³
Volume of water and stone = 35 cm³
Volume of stone was 5 cm³ = true or false
Solution:
To check weather the given volume of stone is true or not we have to calculate the volume of stone from given data.
Volume of stone = (volume of water + stone ) - volume of water
Now we will put the values.
Volume of stone = 35 cm³ - 30 cm³
Volume of stone = 5 cm³
Thus the given value is true. The volume of stone is 5cm³.
Why is governmental funding of research important?
A. The government makes sure all scientists get the same amount of
money.
B. The government grants funding only to scientists whose research
won't harm people.
C. Scientists work for the government, which is where they get their
money from.
D. The government determines what is right and wrong for everyone.
Answer:
D. The government determines what is right & wrong for everyone
Explanation:
Which would be least helpful in reducing indoor pollution?
O A. Increasing airflow
B. Using all-natural cleaning products
C. Having house plants
O D. Having thick carpet
thick carpet!!!Answer:
Explanation:
just got right on quiz:)
4. The half-life for a 100-gram sample of radioactive element X is 5 days. How much of element X remains after 10 days have passed?
A. 25 g
B. 50 g
C. 75 g
D. 100 g
Electrons have single negative charges. What does this mean?
Na: 1s22sC2p 3s
C=
D =
E =
Answer:
C = 2
D = 6
E = 1
Explanation:
just took the test :)
F. A rigid steel cylinder has a volume of 20.0 L. It is filled with N2 gas to a final pressure of 205 atm at 27.0 S. How
many moles of N2 gas does the cylinder contain?
Answer:
don't know this but going to figure out
Plz help me and I promise I will make you he brainiest
Answer:
2
Explanation:
1 is definitely wrong
density must be lower to atop another liquid
in 3 ,I consider the example of water and oil whi has a lower boiling point
Answer:
2
Explanation:
A. Can you use mass alone to predict whether an object will sink or float?
Answer:
yess
Explanation:
The number of electrons (e- ) is
Answer:
The number of electrons in a neutral atom is equal to the number of protons. The mass number of the atom (M) is equal to the sum of the number of protons and neutrons in the nucleus. The number of neutrons is equal to the difference between the mass number of the atom (M) and the atomic number (Z).
Explanation:
The chemical formula for sodium sulfate is Na2SO4. How many sulfur atoms are in the formula for sodium sulfate?
Answer:
1
Explanation:
there is only one sulphur (S) atoms in the formula for sodium sulphate
The chemical formula for sodium sulfate is Na₂SO₄.One sulfur atoms are in the formula for sodium sulfate.
What is chemical formula ?The term chemical formula shows the elements that create the compound and the numbers of atoms of each element in the smallest unit of that compound, be it a molecule or a formula unit.
Chemical formulas are classified into three types: empirical, molecular, and structural.
Empirical formulas depict the simplest whole-number ratio of atoms in a compound, whereas molecular formulas depict the number of each type of atom in a molecule and structural formulas depict how the atoms in a molecule are bonded to each other.
Thus, the chemical formula for sodium sulfate is Na₂SO₄. In sodium sulphate two molecules of sodium, one atom of sulfur, and four atoms of oxygen are present.
To learn more about the chemical formula, follow the link;
https://brainly.com/question/11995171
#SPJ6
Round to 4 significant figures. 9.87553
Answer:
9.876
Explanation:
fog forms when a water vapor changes to the___ state of matter?
Answer:
Gas
Explanation:
Earth’s tides are affected by the gravitational pull of the Sun and the Moon, but mainly the Moon because the Moon is _______(1) Each day, each costal region on Earth experiences two high tides and two low tides in a ______(2) time period. This is because the gravitational attraction of the Moon creates ______(3) on two opposite sides of the planet. Two spring tides occur monthly, when the Moon is in its new and full phases. During these phases, the Moon and Sun are oriented ______________________,(4) which gravitationally pulls the water on Earth in the same direction, creating a large tidal range.
(1) A. closer
B. larger
C. denser
(2) A. 12-hour
B. 16-hour
C. 24-hour
(3) A. tidal bulges
B. moon phases
C. orbits
(4) A. in a straight line
B. at a right angle measuring 90 degrees
C. at an acute angle measuring 23 degrees
Answer:
1 closer
2 24hours
3 tidal bulges
4 in a straight line
Explanation:
Tides have been the effect of the sea with the gravitational pull of the sun and moon.
1. Earth’s tides are affected by the gravitational pull of the Sun and the Moon, but mainly the Moon because the Moon is closer to the earth.
In spite of high pull of the Sun, the distance of moon from earth results in increased effect of moon gravitational pull than Sun.
2. Each day, each coastal region on Earth experiences two high tides and two low tides in every 24 hours time period.
The daily tides has been resulted at the coast with the moon revolution around the earth's rotation.
3. This is because the gravitational attraction of the Moon creates tidal bulges on two opposite sides of the planet.
The effect of the moon gravitational force results in the bulging or the pulling force to the sea, resulting in the diurnal tides.
4. Two spring tides occur monthly, when the Moon is in its new and full phases. During these phases, the Moon and Sun are oriented at a right angle measuring 90 degrees which gravitation pulls the water on Earth in the same direction, creating a large tidal range.
For more information about the high and low tides, refer to the link:
https://brainly.com/question/296886
how many atoms are in 4 Mg(OH)2 ?
Answer:
20 atoms
broo this is easy plz give me harder questions smh
What is the difference between an atom and an element? a An atom cannot be cut into smaller, but an element is a group of atoms that are the same b An atom makes up matter but an element does not c An atom can be combined but an element cannot be combined d An atom can be cut apart but an element cannot
Answer:
c.
Explanation:
One of the main differences between an atom and an element is that an atom can be combined but an element cannot be combined. There are many combinations of atoms that make up different gases, liquids, and solids each with a unique makup. For example, water is made up of two hydrogen atoms and one oxygen atom (H20). Elements are made up of only the same type of atom. For example, the element Hydrogen can only contain hydrogen atoms, while the element Carbon can only contain carbon atoms.
Make a funny sentence for ductile
Here is an example of mercury, It HAS to be for Magnesium.
¨I’m a highly stable element, so you can count on me¨
Copper and tin wire are both ductile and able to be stretched.
A rectangular solid has a length of 3 cm a height of 4 cm and a width of 5 cm what is the solid volume ?
Why do you need to use a roman numeral with transition metals, but not with the alkali and alkali earth metals?
Answer:
Because they have variable oxidation states
Explanation:
Transition metals are designated with roman numerals because they have variable oxidation states.
They do not form a single ionic ion as seen by the main group elements.
Transition metals are known for their variable ions they form in ionic state. They belong to the d-block on the periodic table. They are also known to from colored solutions.Did you title your lab report?
Did you state the purpose of the investigation?
Did you include a brief overview of the investigation?
Materials and Procedure
Did you make a list of materials? Did you include quantities and SI units?
Did you present the steps of the procedure as a numbered list?
Did you note any changes to the original procedure?
+
The density of a liquid substance is 0.95 g/mL. Three students calculated the density as 0.56 g/mL. Calculate the percent error.
0 41.05 %
41.0 %
O 41.053%
O 41%
Answer:
The answer is 41.05 %Explanation:
The percentage error of a certain measurement can be found by using the formula
[tex]P(\%) = \frac{error}{actual \: \: number} \times 100\% \\ [/tex]
From the question
actual density = 0.95 g/mL
error = 0.95 - 0.56 = 0.39
So we have
[tex]p(\%) = \frac{0.39}{0.95} \times 100 \\ = 41.0526315...[/tex]
We have the final answer as
41.05 %Hope this helps you
How many O's are in Al2(SO4)3 ?
Answer:
12 moles O
In one mole of aluminum sulfate, Al2(SO4)3 , there are 2 moles Al atoms, 3 moles sulfur atoms, and 12 moles O atoms
Explanation:
Answer:
1...
Explanation:
What is the wavelength of a radio wave with a frequency of 3.1 X 106 Hz?
Answer:
Assuming that the frequency of a wave is 3 multiplied to 109 Hertz, then we use wave velocity over frequency. Therefore, 327 Hertz has a wavelength of approximately 917 kilometers and has a velocity of at least 300,000 kilometers per second
Explanation:
hope it helps give cronw ples
One hour of bicycle riding can require 500-900 kcal of energy, depending on the speed, the terrain, and the weight of the racer. An individual wants to lose weight by riding at a modest effort, consuming 505 kcal of energy per hour. How many hours must he ride to lose 21.0 pounds of body fat? One gram of body fat is equivalent to 7.70 kcal of energy. There are 454 g in 1 lb.
Answer:
145 hours
Explanation:
Since one hour of riding a bicycle takes up 505 kcal of energy. It is also stated that one gram of body fat is equal to 7.70 kcal. Also, it is given that 1 pound of body fat is equal to 454 g.
Hence;
1 Ib= 454 g
21 Ib= 21 × 454/1 = 9534 g
But
1g of body fat = 7.70kcal
9534 g of body fat = 9534 × 7.70 kcal/1 = 73411.8 kcal
If 505 kcal is lost in 1 hour
73411.8 kcal is lost in 73411.8 kcal × 1hour/505k cal = 145 hours
Quick chem question!
I will mark as BRAINLIEST!!!
Answer:
D
Explanation:
A and C sounds not logic
B is wrong since all the molecules has different numbers of carbon and hydrogen
D sounds correct because triple covalent bond exist at the C-C bonding