What is energy and what is the formula of energy

x for a smaller magnet at the position marked zin

Answer:

A. Mg+2

Explanation:

im not sure, but since it lost two electrons which have a negative charge it gained two charge.

Explanation:

Khi một hạt thực hiện SHM Đang chuyển động từ vị trí cực biên về vị trí trung bình, thì vận tốc và gia tốc cùng hướng, tức là hướng về vị trí trung bình

Answer:

2. Letter C all those in the list are non living

3. Letter A a skunk is a living organism that shapes its environment

5. Letter A when talking about population it usually refers to a single type of species in that area

6. Letter B Niche (just recently heard of the word in ecology)

Answer:

Time

Explanation:

To find velocity (also known as distance), you need both the speed and time.

Answer:

Find answers below.

Explanation:

1. Radiant: the energy of light.

2. Light: makes it possible to see things.

3. Sun: a source of light. This source of light is referred to as solar energy and it's renewable source of energy.

4. Crest: top of wave. Thus, it's typically the highest part of an electromagnetic wave.

5. Trough: bottom of wave. Thus, it's typically the lowest part of an electromagnetic wave.

6. Wavelength: distance from one point on one wave to the same point on the next wave.

7. Infrared light: it has longer wavelengths than visible light.

8. X-rays: shorter wavelengths than visible light.

Electromagnetic waves is a propagating medium used in all communications device to transmit data (messages) from the device of the sender to the device of the receiver.

An electromagnetic spectrum refers to a range of frequency and wavelength that an electromagnetic wave is distributed or extends. The electromagnetic spectrum comprises of gamma rays, visible light, ultraviolet radiation, x-rays, radio waves, and infrared radiation.

Answer:

prefix that means 1/100 = Centi

prefix that means 1,000 = Kilo

prefix that means 1/1000 = Milli

Explanation:

Answer:

Explanation:

There are a couple of things we need to clear up before we start the problem. First of all, we are given an angle in the problem along with an initial velocity. BUT this is what I call a "blanket" velocity: it is neither the upwards velocity nor is it the horizontal velocity. In order to find either the upwards velocity or the horizontal velocity we have to use either the sin or the cos function, respectively. Since we are working ONLY in the y-dimension, which is up and down, we use the sin function along with the given velocity to find the upwards velocity of the ball. Secondly, we have to know that the final velocity at the max height of the ball is 0. So here is what we have:

v₀ = 12sin14 so

v₀ = 2.9 m/s

a = -9.8 m/s/s

v = 0 m/s

Δx = ??? m

The equation we need is

v² = v₀² + 2aΔx and filling in:

0 = (2.9)² + 2(-9.8)Δx and

0 = 8.4 - 2.0 × 10¹Δx and

-8.4 = -2.0 × 10¹Δx so, to the correct number of sig dig,

Δx = 170 m

Answer:

there it is fella tried on ma own observation

Given, mass of the man, m=60kg

Kinetic energy of the man, E

k

=750J

If v is the velocity of the man, then

E

k

=

2

1

mv

2

or v=

m

2E

k

=

60

2×750

=5m/s

Answer:

[tex]{ \bf{kinetic \: energy = \frac{1}{2}m {v}^{2} }} \\ { \tt{ 750= \frac{1}{2} \times 60 \times {v}^{2} }} \\ { \tt{ {v}^{2} = 25 }} \\ \\ { \tt{v = \sqrt{25} }} \\ { \bf{velocity = 5 \: m {s}^{ - 1} }}[/tex]

Answer:

speed

(distance per time)

Kathy is faster btw

Answer:

if there is only one planet in the universe and the ball is there it will have 0 kinetic energy if the ball is in the very center of that planet only if the planet itself is absolutely motionless. its at its highest if the planet is moving away from the ball at a slightly faster speed forever. Between point A and B both potential energy and kinetic energy are at perfect 0.

Explanation:

never will have a measurable kinetic or potential energy status unless every single object is included in the calculation.

What is the activity of a source that emits 1,200 particles per minute?

[tex]\boxed{ B. \:20 \:Bq }[/tex]

Explanation:

20 Bq is the activity of a source that emits 1,200 particles per minute. Activity is the number of decays per second. The SI unit for activity is becquerel (Bq).

[tex]\bold{ \green{ \star{ \orange{Mystique35}}}}⋆[/tex]

Answer:

B) 20 Bq

The activity of a source that emits 1,200 particles per minute is 20 Bq.

-------------------------

☆hope it helps

☆have a great day!!

Answer:

556

Explanation:

Answer:

Given,

w= 180J

s=60m

W=F×s

180=F×60

180/60=F

F= 3 N

Answer:60

Explanation:

Answer:

the ballon is purple

Explanation:

Answer:

300cm^3

Explanation:

1ml = 1cm^3

=>300 ml = 300 cm^3

Explanation:

First find the area of the entire floor:

Area of a rectangle= length × width

( 4000mm× 3600mm)

14400000mm²

Area of one square tile??= side ×side

12cm×12cm

144cm²

Convert cm to mm

1cm²=100mm²

144cm²=144cm²/1cm²×100mm²

=14,400mm²

Number of tiles required to cover the entire floor= 14400000mm²/14400mm²

=1000

Answer:

The ratio of forces is 22 : 3.

Explanation:

Case I:

initial velocity, u = 35 mph

final velocity, v = 0

time, t = 15 ms

Case II:

initial velocity, u = 35 mph

final velocity, v = 0

time, t' = 110 ms

let the mass is m.

According to the Newton's second law, the force is given by the rate of change of momentum.

So

[tex]F =\frac{m(v-u)}{t}\\\\F'= \frac{m(v-u)}{t'}\\\\So, \frac{F}{F'} =\frac{t'}{t}\\\\\frac{F}{F'}=\frac{110}{15}=22:3[/tex]

Answer:

Infinite

Explanation:

Young's modulus is infinite and bulk modulus is zero.

Answer:

Young's modulus is the ratio of tensile stress ( force of elasticity ) to tensile strain ( extension ).

Explanation:

[tex]E = \frac{stress}{strain} [/tex]

Answer:

1. Efficiency

2. Kinetic energy

3. Pulley

4. Screw

5. Wedge

Explanation:

1. Efficiency: the ratio of work output to work input or the ratio of actual mechanical advantage (AMA) to ideal mechanical advantage (IMA).

Mathematically, the efficiency of a machine is given by the formula;

[tex] Efficiency = \frac {MA}{IMA} * 100 [/tex]

2. Kinetic energy: the energy of a moving object. Kinetic energy (KE) is an energy possessed by an object or body due to its motion.

Mathematically, kinetic energy is given by the formula;

[tex] K.E = \frac{1}{2}MV^{2}[/tex]

Where;

K.E represents kinetic energy measured in Joules.

M represents mass measured in kilograms.

V represents velocity measured in metres per seconds square.

3. Pulley: a grooved wheel over which a rope can move. It is made up of a wheel and rope which allows force to be multiplied such as in a drawing well.

4. Screw: a double-sided inclined plane. It is held in position and then used to tighten two or more objects together.

5. Wedge: an inclined plane wrapped around a cylinder. It can be used to split objects into halves.

Answer:

20 = 30 / t1

t1 = 3/2

40 = 30 / t2

t2 = 3/4

average speed = total distance / total time taken

= 30 + 30 / 3/2 + 3/4

= 60 /9/4

= 60 × 4/9

= 26.667

Answer:

The refractive index of the outer coating is 1.52.

Explanation:

Refractive index of interior part, n' = 1.97

critical angle, C = 50.4°

Let the refractive index of the coating is n.

Use the Snell's law,  

[tex]n\times sin r = n'\times sinC\\\\n\times sin 90 = 1.97 \times sin 50.4\\\\n = 1.52[/tex]

Answer:

105.6 KJ

Answer

3.7/5

4

hope this will help you friend.

Answer:O que faz o longa se destacar é seu cenário mergulhado na cultura chinesa e a delicadeza com que o luto e sua superação são tratados.

Explanation:

Por que se você pensar ela estava sempre buscando superar a morte da mãe.

Answer:

Linear motion, also called rectilinear motion, is one-dimensional motion along a straight line, and can therefore be described mathematically using only one spatial dimension.

Explanation:

Rotation around a fixed axis is a special case of rotational motion. The fixed-axis hypothesis excludes the possibility of an axis changing its orientation and cannot describe such phenomena as wobbling or precession