This image shows:
Which of the following organisms is not a consumer in this ecosystem?

Answer:

Fractional distillation works because the various liquids have different points of boiling. When heating the mixture: As they enter a column below their boiling point temperature, vapors condense. Fluid flows from the column

Explanation:

Answer:

gold wire (Au)

Explanation:

A substance that cannot be separated or broken down into simpler substances by chemical means is an element.

Between the given options only gold wire is an element, Au.

A way of knowing that it is an element is noticing that its formula is a single symbol which corresponds to an element found in the periodic table, unlike a combination of said symbols (like NaCl or H₂O).

Answer:

I think it is Ea Nino I may be wrong though dont hold me to it

Answer:

low

Explanation:

We were informed in the question that the student had incorrectly recorded the mass of cup + sample as 2.20 g but inadvertently used 2.00 g in the calculations.

This error will cause a slight decrease in the mass of water and ultimately decrease the number of moles of water in the hydrate.

What i am saying is that the number of moles of water obtained in the calculation will be artificially low.

Answer:

the cerebrum

Explanation:

answer is A

Answer:

D is correct

Explanation:

EDG 2021

Answer:

Explanation:

Atmosphere - the envolpoe of gasses sourounding the earth or another planet or the air in any particular place. The atmosphere protects us from the suns harmful rays, carrys cloud full of water so it can rain all over the world, and have oxygen, which is nessecary for survival to all living things.

Answer:

Answer:

                   Potassium Nitride is composed of the greatest number of atoms.

Explanation:

find the number of atoms present in each compound we will write down their molecular formulas and then we will add up the number of atoms present in them.

A: Dinitrogen Monoxide:

                                       Chemical formula of Dinitrogen Monoxide is N₂O. Therefore, it contains two atoms of Nitrogen and one atom of oxygen Hence, in total it contains 3 atoms.

B: Sodium Chloride:

                               Chemical formula of Sodium Chloride is NaCl. Therefore, it contains one atom of Sodium and one atom of Chlorine Hence, in total it contains 2 atoms.

C: Potassium Nitride:

                                       Chemical formula of Dinitrogen Monoxide is K₃N. Therefore, it contains three atoms of Potassium and one atom of Nitrogen Hence, in total it contains 4 atoms.

D: Carbon Dioxide:

                               Chemical formula of Carbon Dioxide is CO₂. Therefore, it contains one atom of Carbon and two atoms of Oxygen Hence, in total it contains 3 atoms.

Explanation:

Answer:

Land covers refer to all the manufactured structures and vegetation that covers the land it includes all vegetation including plants, shrubs, trees, and other man-made structures too.

On other hand, Land use is the term that explains the use of the land by the different human activities that are occurred on land that are directly related to the land.

Land cover influences land use by utilizing particular land such as parks, ponds, or other uses according to the land. and humans can cause changes in both when they urbanize the area or land.

Answer:

DBE

Explanation:

Cause I got it right

The correct options for Charles's law, Gay-Lussac's Law and Boyle's law are D, B and E respectively.

Charles's law states that, under the assumption of constant pressure, the volume of a gas increases or decreases with its temperature. As the temperature increases, the gas molecules move more quickly and occupy more space, increasing the volume of the gas.

Gay-Lussac's law states that, assuming a constant volume, the pressure and temperature of a gas are exactly related. Increasing temperature causes the gas molecules to become more kinetically energetic and collide with the walls of the container more frequently, increasing the pressure.

Boyle's law states that at a given temperature, the pressure and volume of a gas are inversely proportional. The reduced volume forces the gas molecules into a smaller area, increasing the chance of collisions with the container walls and pressure.

Therefore, the correct options for Charles's law, Gay-Lussac's Law and Boyle's law are D, B and E respectively.

Learn more about Boyle's law, here:

https://brainly.com/question/21184611

#SPJ2

Answer:

Explanation::::

Answer:

8 neutrons

A is the number of neutrons plus protons in the nucleus. However, we already know that there are 7 protons. Therefore, there must be 8 neutrons in the nucleus to add up to 15. Table 3.

Element Symbol Number of Neutrons

carbon 146C 8

nitrogen 147N 7

157N 8

oxygen 168O 8

Explanation:

Answer:

Decomposition.

Explanation:

Decomposition Reactions T hose reactions in which a single substance (reactant) splits up into two or more simpler substances (products) are known as decomposition reactions. These reactions are carried out by supplying energy in form of heat, electricity or light which breaks that substance into simpler substances

Answer:

No One is going to answer all this because it hard to type it all in her. its easy to search it up

Explanation:

Answer:

C)The same bond in a different molecule has a different energy. For example, O-H in water versus ethanol has different energies.

Explanation:

This is true going by the the statement about the bond energies and the bonding being different among the various elements. In the example given which is between ethanol and water, the bonds which exist among the elements is stronger in water than in ethanol. That is why, ethanol is easily combustible than water.

Answer:

The same bond in a different molecule has a different energy. For example, O-H in water versus ethanol has different energies.

Explanation:

Answer:

Likely Xenon, [tex]\rm Xe[/tex].

Explanation:

The average kinetic energy of particles of a gas at a given temperature and pressure should be the same (regardless of the exact composition of the particle.)

For example, let [tex]m_1[/tex] and [tex]m_2[/tex] denote the mass of each particle of two gases, and let [tex]v_1[/tex] and [tex]v_2[/tex] denote the average speed of particles of each gas.

Average kinetic energy of particles of the first gas: [tex]\displaystyle {\rm KE_1} = \frac{1}{2}\, m_1 \cdot ({v_1})^{2}[/tex].

Average kinetic energy of particles of the second gas: [tex]\displaystyle {\rm KE_2} = \frac{1}{2}\, m_2 \cdot ({v_2})^{2}[/tex].

If the temperature of these two gases are the same, [tex]\rm KE_1 = KE_2[/tex]. Hence:

[tex]\displaystyle \frac{1}{2}\, m_1 \cdot ({v_1})^{2}= \frac{1}{2}\, m_2 \cdot ({v_2})^{2}[/tex].

[tex]\displaystyle \frac{v_1}{v_2} = \frac{\sqrt{m_2}}{\sqrt{m_1}}[/tex].

In other words, the average velocity of particles of each gas (at the same temperature and pressure) is inversely proportional to the square root of the mass of one particle of each gas.

Similarly, at the same temperature and pressure, particles of the four gases in this question would have the same average kinetic energy. However, the gas with the largest per-particle mass would have the slowest average velocity for its particles.

Look up the relative atomic mass of the particles:

Calculate the formula mass of each gas. That value would be proportional to the average mass of each particle of the gas:

Among these four gases, each particle of xenon, [tex]\rm Xe[/tex], has the largest per-particle mass. Hence, at the same temperature and pressure, particles of Xenon would have the slowest average velocity among these gases.

Answer:

Hydroelectric energy, also called hydroelectricity or hydropower, is a form of energy that uses the power of flowing water to generate electricity. There are three main types of hydroelectric energy: impoundment, diversion, and pumped storage.

Explanation:

Answer:

Sulfur needs 2 more electrons to achieve octet in its valence shell.

Explanation:

According to the electronic configuration, 2 electrons are required to be gained by the sulfur to achieve the octet rule.

Electronic configuration is defined as the distribution of electrons which are present in an atom or molecule in atomic or molecular orbitals.It describes how each electron moves independently in an orbital.

Knowledge of electronic configuration is necessary for understanding the structure of periodic table.It helps in understanding the chemical properties of elements.

Elements undergo chemical reactions in order to achieve stability. Main group elements obey the octet rule in their electronic configuration while the transition elements follow the 18 electron rule. Noble elements have valence shell complete in ground state and hence are said to be stable.

Learn more about electronic configuration,here:

https://brainly.com/question/29757010

#SPJ6

Answer:

no

Explanation:

magnesium acetate= Mg(C2H3O2)2

Answer:organic compound is :​ C₄H₈

Explanation: The equation of the reaction of the organic compound burning with excess oxygen gives us the general equation as

C xHy  + 1/2(x+ y/2 )O₂ → xCO₂ + y/2H₂O

We first find the number of moles of CO₂ and H₂O

Number of moles of CO₂= Mass/ molar mass

= 17.6g/ 44g/mol ( 12+ 16 x2)

=0.4 moles

Number of moles of H₂O= Mass/ molar mass

= 7.2g/ 18g/mol ( 1 X 2+ 16)

=0.4 moles

From the reaction , we can see that  

x = 0.4

and  [tex]\frac{y}{2}[/tex]= 0.4  such that y= 0.4 x 2= 0.8

Their ratios become

[tex]\frac{x}{y}[/tex] =[tex]\frac{0.4}{0.8}[/tex]= [tex]\frac{4}{8}[/tex]

Therefor the organic compound CxHy  = C₄H₈

​  

Answer:

[tex]0.21\ \text{kg/s}[/tex]

Explanation:

P = Pressure = [tex]0.48\ \text{atm}=0.48\times 101325\ \text{Pa}[/tex]

V = Volume = [tex]450\ \text{L/s}=450\times 10^{-3}\ \text{m}^3/\text{s}[/tex]

R = Gas constant = [tex]8.314\ \text{J/mol K}[/tex]

T = Temperature = [tex](264+273.15)\ \text{K}[/tex]

The reaction is

[tex]2H_2S+3O_2\rightarrow 2SO_2+2H_2O[/tex]

From ideal gas equation we have

[tex]PV=nRT\\\Rightarrow n=\dfrac{PV}{RT}\\\Rightarrow n=\dfrac{0.48\times101325\times 450\times 10^{-3}}{8.314\times (264+273.15)}\\\Rightarrow n=4.9\ \text{mol}[/tex]

Moles of [tex]SO_2[/tex] produced is

[tex]\dfrac{2}{3}\times 4.9=3.267\ \text{moles}[/tex]

Molar mass of [tex]SO_2[/tex] = 64.066 g/mol

Production rate is

[tex]3.267\times 64.066=209.3\ \text{g/s}=0.21\ \text{kg/s}[/tex]

The rate at which sulfur dioxide is being produced [tex]0.21\ \text{kg/s}[/tex].

Answer:

c

Explanation:

CI or O

Carla Vista Company has the following information available for September 2020.

Unit selling price of video game consoles $410

Unit variable costs $328

Total fixed costs $36,900

Units sold 600

Compute the unit contribution margin.

Unit contribution margin enter the unit contribution margin

Prepare a CVP income statement that shows both total and per unit amounts.

Compute Carla Vista’ break-even point in units.

Break-even point in units enter Break-even point in units units

Prepare a CVP income statement for the break-even point that shows both total and per unit amounts.

The more metallic element  pair is Cl or O. Therefore, option C is correct.

Except for hydrogen, which is a nonmetal, the elements are arranged in a triangle with the metals to the left, the nonmetals to the right, and the metalloids to the immediate right of the triangle.

Metal atoms are bound together by metallic bonds to form solids known as metallic solids. Metal solids include things like copper, gold, and zinc, for instance. Since cesium is the last naturally occurring alkali metal, it has the most metallic characteristics.

The non-metal components, like as rock and rubbish, are subsequently removed from the ore during processing. The subsequent melting and combining of various metal components yields metal alloys. A solid metal alloy substance is produced when the freshly combined metal compound has cooled.

Thus, option C is correct.

To learn more about metallic element, follow the link;

https://brainly.com/question/24309770

#SPJ2

Answer:

Following are decreasing order to this question:

Explanation:

Viscosity and surface tension both are inter-molecular by nature (IMFs)

The pentane becomes non-polar and just not H-bondable, so LDF alone would be likely (London Dispersion Force)

Pentanal, but H-bond => is impossible (Dipole-Dipole)

Pentanol is also an OH group, so H-bond => is probable (Hydrogen Bonding)

Higher air tension and viscosity than higher IMFs (because the atoms of fluids are more drawn). To lower the IMF (and therefore the viscosity/surface stress decreases)

pentanol

pentanal

pentane

Answer:

Explanation:

That's correct. Once Aluminum becomes an ion, it is very hard to force it to take back its electrons. Only a few elements can do it. Iron is not one of them.

Answer: Molar mass of [tex]CuSO_4.5H_2O[/tex] is 249.68 g/mol.

Explanation:

Molar mass is the mass of 1 mole of the molecule. It is calculated by adding masses of all the atoms in the given molecule.

[tex]CuSO_4.5H_2O[/tex] contains one atom of copper , 1 atom of sulphur, 9 atoms of oxygen and 10 atoms of hydrogen

Mass of copper = 63.5  g/mol

Mass of sulphur =  32.06 g/mol

mass of oxygen = 16.00 g/mol

Mass of hydrogen = 1.008 g/mol

 Thus mass of [tex]CuSO_4.5H_2O[/tex] = 63.5(1)+32.06(1)+16.00(9)+1.008(10)=249.68 g

Molar mass of [tex]CuSO_4.5H_2O[/tex] is 249.68 g/mol.

Answer:

sdasdasddsafsadsfds

Explanation:

Answer:

49 вот правильный ответ