The energy released by a nuclear fusion reaction is produced when
1. energy is converted to mass
2. mass is converted to energy
3. heat is converted to temperature
4. temperature is converted to heat

Answer:

I'm pretty sure it is 8.7

Explanation:

and btw you are fineeee

Answer:

d an attraction between positive ions and electrons

Answer:

a chemical compound

Explanation:

copper(ii) chlorate is a chemical compound of the transition metal copper and the chlorate anion with basic formula cu(cio)3 and 2

Answer:

40

Explanation:

The total mass of calcium in the products is 40

The mass number (represented by the letter A) is defined as the total number of protons and neutrons in an atom. Consider the table below, which shows data from the first six elements of the periodic table. Consider the element helium. Its atomic number is 2, so it has two protons in its nucleus.

Together, the number of protons and the number of neutrons determine an element's mass number: mass number = protons + neutrons. If you want to calculate how many neutrons an atom has, you can simply subtract the number of protons, or atomic number, from the mass number.

Learn more about mass of calcium at

https://brainly.in/question/12273172

#SPJ2

Answer:

If AT and q are negative, then heat flows from an object into its surroundings. If a substance gains thermal energy, its temperature increases, its final temperature is higher than its initial temperature, then AT>0 and q is positive.

Answer:

c

Explanation:

Answer:

the ocean, the ocean floor basalts, evaporite deposits and reduced marine sediments.

Explanation:

Answer:

Cl < P < Mg < Na

Explanation:

Cl must have the smallest radius because it is located to the right of the remaining elements on the same row. P  must have the second smallest radius because it is located to the right of the remaining elements on the same  row. Mg must have the Third smallest radius because it is located to the right of Na on the same row.  Therefore, Na has the Largest radius.

I hope it helps.

Answer: Na2SO4

The molecular formula for sodium sulphur and oxygen​ is: (Na2SO4)

,  Hope this helps :)

Have a great day!!

Answer:

No. Although alkali metals and alkaline earth metals are found in nature, they  are not found as pure elements. Group 1 and 2 are found in their chemical compounds, not pure form.

Answer:

Transpiration is the correct answer mark me brainliest

Answer:

Carbon is in carbon dioxide, which is a greenhouse gas that works to trap heat close to Earth. Carbon is the chemical backbone of life on Earth. Carbon compounds regulate the Earth's temperature, make up the food that sustains us, and provide energy that fuels our global economy. Most of Earth's carbon is stored in rocks and sediments. The rest is located in the ocean, atmosphere, and in living organisms

Explanation:

Hope it helps. Can you give me BRAINLIEST ANSWER. Thank you

In this exercise we want to calculate the amount of moles, so this is going to be:

[tex](4.6)(10^{-3}) \ mols \ CO_2[/tex]

Knowing that Henry's law is given by:

[tex]C = KHP[/tex]

Where constants are given by:

Before we can find the concentration of CO2 (and hence the moles of CO2), we first need to find its partial pressure.  We look up the vapor pressure of water at 25º and find it to be 0.03 atm.  Since the total pressure is equal to 0.1 atm, this mean the partial pressure of:

[tex]CO_2 = 0.1 \ atm - 0.03 \ atm = 0.07 \ atm[/tex]

Now using Henry's law, we find the concentration:

[tex]C = (0.033)*( 0.07) = (2.31)*(10^{-3})[/tex]

Converting to moles of CO2, we have:

[tex](2.31)*(10^{-3})*( 2) = (4.6)*(10^{-3})[/tex]

See more about concentration at https://brainly.com/question/3045247

Answer:

eight oxygen atoms

Explanation:

This formula shows that in one mole of this compound, there are 3 moles of Ca atoms that combine with 2 moles of the PO4(phosphate) groups, which gives a total of 2 moles of P atoms and 8 moles of 0 atoms.

Answer:

???

Explanation:

I have no clue sorry

helium is in group 8 and period 1

Answer:

The highlighted words in the explanation.

Explanation:

A clue comes by considering the noble gas elements, the rightmost column of the periodic table. These elements—helium, neon, argon, krypton, xenon, and radon—do not form compounds very easily, which suggests that they are especially stable as lone atoms. What else do the noble gas elements have in common?

This problem provides information about the decomposition of copper(II) nitrate to copper(II) oxide and dinitrogen monoxide; for example, it is endothermic, the enthalpies of formation and the chemical reaction, as well as copper (II) sulfate which when dissolved in water, exhibits a temperature decrease:

[tex]2Cu(NO_3)_2(s) \rightarrow 2CuO(s) + 4NO_2(g) + O_2(g)[/tex]

First of all, we can draw the reaction pathway as shown on the attached figure, by taking into account the positive enthalpy change as it is endothermic, so that the products turn out with higher energy than the reactants, for it to be positive. In addition, keep in mind that top point is the activation energy the reaction needs to take place.

Next, we calculate the enthalpy change for this reaction by using the general formula which subtracts the enthalpy of formation of products and reactants with each species' correct stoichiometric coefficient:

[tex]\Delta H=2\Delta _fH_{CuO}+4\Delta _fH_{NO_2}+\Delta _fH_{O_2}-2\Delta _fH_{Cu(NO_3)_2}[/tex]

So we plug in the given enthalpies of formation:

[tex]\Delta H=2(-157.3)+4(33.2)+(0)-2(-302.9)=424.0 kJ/mol[/tex]

Finally, we go over the calorimetry experiment, whereby the total heat absorbed by the copper(II) sulfate is calculated via the general heat equation, which includes the heat loss from the solution of water and the salt:

[tex]Q_{rxn}=-mC_w\Delta T\\\\Q_{rxn}=-(100+25)g*4.18\frac{J}{g\°C}*-2.9\°C=1515.25J[/tex]

By dividing the previous answer by the moles of salt:

[tex]n=25.0g*\frac{1mol}{249.7g}=0.100mol[/tex]

We can obtain the enthalpy change of solution of the copper salt:

[tex]\Delta _{dissolution}H=\frac{1,515.25J}{0.100mol} \\\\\Delta _{dissolution}H=15,134J/mol=15.1kJ/mol[/tex]

To conclude, it is important to note that one possible source of error is we are assuming the solution has the same specific heat to that of water and that is not necessarily true. Also, we are neglecting any heat transfer to and from the surroundings despite the polystyrene beaker is considered a heat isolator, which means the results cannot necesarilly be accurate and the enthalpy change could have turned out higher or lower in a rigoruous experiment.

Learn more:

Answer:

1) 1.39 * 10²³ atoms

Explanation:

Answer:

Oxide sugar dissolved in water pond

because water + sugar= sugar melts but the oxide purifys the water.

Explanation:

#carryonlearning!

Tornadoes form when updrafts from thunderstorms begin to interact with strong wind shear and develop a rotating column of air.

Updrafts are powerful vertical currents of air that occur within thunderstorms, caused by the rapid heating of the Earth's surface and the subsequent convective process. These updrafts carry warm, moist air upward, creating a conducive environment for the formation of severe weather phenomena.

When the updrafts encounter wind shear, which is the change in wind speed and direction with height, it can lead to the development of horizontal vorticity. Wind shear creates a rotating motion within the storm, where air at different heights starts to rotate at different speeds, generating a horizontal spin.

As the updraft continues to intensify, it tilts the rotating column of air from horizontal to vertical, forming a mesocyclone. The mesocyclone is a critical component in tornado formation. It acts as a localized area of strong rotation within the storm, extending from the cloud base to the mid-levels of the atmosphere.

Under specific conditions, such as the presence of a strong updraft, a well-developed mesocyclone, and further enhancement from other atmospheric factors, the mesocyclone can contract and intensify into a tornado. The process is complex and influenced by various meteorological factors, but the interaction between updrafts, wind shear, and the development of rotation plays a fundamental role in tornado formation.

For such more questions on updrafts

https://brainly.com/question/20273319

#SPJ8

Answer:

54.75 mL

Explanation:

First calculate the number of moles of NaCl in the 150mL solution of NaCl

0.0365 moles should be present on 1000cm3 or 1dm3 of water.

1L = 1 dm3

1 mL = 1 / 1000 dm3

150 mL = 150/1000 dm3 = 0.15 dm3

If x moles are present in 0.15 dm3,

x/ 0.15 = 0.0365

We get x= 0.0365 × 0.15 mol

Now x amount of moles should be taken from the initial 0.100 M NaCl solution

So 0.1 moldm-3 = 0.0365× 0.15 mol / V

we get V = 0.05475 dm3

V= 0.05475 L

V= 54.75 mL

Answer:

B

Explanation:

so A is nosense C and D the question is saying the stament for a being repersentation of solid not whether eletric or not

Answer:

25.1 moles

Hence it can be seen that when 25.1 moles of carbon dioxide gas react with excess hydrogen gas, 25.1 moles of methane gas are produced.

Rusting is an electrochemical reaction. Iron rusts faster when alloyed with cobalt than when alloyed with manganese because, in the iron-manganese alloy, manganese is rendered the anode and iron is rendered the cathode

An alloy is a combination of two metals. There are various reasons for producing alloys such as greater tensile strength, corrosion resistance and improved aesthetic appearance.

When iron is alloyed with cobalt, the iron rusts faster than pure iron because iron is rendered the anode and cobalt is rendered the cathode. When the iron is alloyed with manganese, it rusts more slowly than pure iron because in the iron-manganese alloy, manganese is rendered the anode and iron is rendered the cathode.

Missing parts;

An iron object alloyed with cobalt rusts more quickly than a pure iron object. However, an iron object alloyed with manganese rusts less quickly than a pure iron object under the same conditions. This is true because

(1) cobalt is a stronger reducing agent than iron

(2) iron is a stronger reducing agent than manganese

(3) cobalt exhibits more metallic character than either iron or manganese

(4) in the iron-manganese alloy, manganese is rendered the anode and iron is rendered the cathode

(5) in the iron-cobalt alloy, cobalt is rendered the anode and iron is rendered the cathode

Learn more: https://brainly.com/question/14281129

Answer:

I think it's 2.50M IM NOT SURE THOUGH SO I RECOMMEND WAITING FOR ANOTHER ANSWER

Answer:

the answer is 150 in centimeters

When tiny droplets of one liquid are finely dispersed within another liquid it is called emulsion.

Emulsion can be defined as the process by which two liquids that are not miscible come together to form a mixture.

The emulsion mixture usually consists of an oil phase and a water phase.

The oil phase appears as droplets when dispersed (mixed with) the water phase.

The uses of emulsion include:

Learn more here:

https://brainly.com/question/17288119