her cleats in the locker room
Which events took place during the Copernican revolution, when most people started to believe in a heliocentric model of the solar system?
if P(2,1) and Q(8,1) are two of the vertices of a rectangle. which of the following cannot be another of the vertices? Show your work.
A. (2,8)
B. (8,2)
C. (2,-8)
D. (-2,8)
Answer:
D. (-2,8)
Explanation:
The other vertices should be (2, x) and (8, x), where [tex]x \neq 1[/tex]. Then, the point that cannot be a vertix is (-2, 8). Hence, the right answer is D.
Why is algae is good for making renewable fuel? and True or false: a car engine must have fossil fuels to work.
*science*
Answer: Algae are believed to be a good source of renewable energy because of its rapid growth rate and its ability to be cultivated in waste water or waste land. Several companies and government agencies are making efforts to reduce capital cost and operating costs and make algae fuel production commercially viable
And it’s true
Explanation:
Because Gasoline is a fossil fuel. Fossil fuels are :
Fossil fuels are the energy rich substances formed from the remains of an organism. Oil coal and natural gas
What equation that passes through a line (1, -1) and (3, 5).
Answer:
so the equation of the line is y = 3x - 1
Explanation:
soln
you find the slopeslope=5- -1
3 - 1
=6
2
slope=3
2. Then you find the equation
y - 5 = 3
x - 2
3. you close multiplication
y - 5 = 3(x - 2)
y - 5 = 3x - 6
4.you correct like terms together
y = 3x - 6 + 5
y = 3x - 1
Enter line segment, point, or ray in the answer box to complete the statement. Sydney described a ruler as a length of plastic that starts at 0 and continues on to 12 inches. The geometric term that best describes Sydney's description is a .
Answer:
Segment
Explanation:
Literally, segment refer to any distance between two points.
Let's assume the length of the ruler is 20inch, this means that the distance 0 inch to 12 inch is a segment of the full length of the ruler.
Another angle to look at the segment is the length of a segment can be measured because it has two end points; the end points are the point where the segment starts and the point where it ends.
So, in the question above, the end points of the segment are 0 inch and 12 inch while the length of the segment is 12inch.
This is calculated by 12 inch - 0 inch = 12 inch.
The above description can't be said of point and rays. Point is any unit position on a line while ray is a distance that starts from a point but do not have any endpoint.