Answers
Its the warm air what helps them also of energy of the sun
Related Questions
Who tryna do these 3 assignments on wizer for me
Answers
When a liquid is insoluble in another liquid, the liquids are said to be?
Answers
Answer:
immiscible
Explanation:
hi, if your looking for extra points (50+) and brainiest here is ur chance, answer this question correctly plz
Answers
Answer:
Answer choice 'C'
Explanation:
As the ball slows after kicking generates maximum Kinetic Energy, the ball slows due to its Kinetic Energy being transferred to surroundings because of atmospheric and surface friction until it stops in a state of static equilibrium.
sorry if im wrong, but im sure its either one.
Calculate the percent composition (out of 100) by weight of potassium in potassium carbonate decahydrate.
Answers
Answer:
12.26%
Explanation:
MM K = 39.1 g/mol
MM K2CO3 . 10H2O = 2x39.1 + 12.01 + 3 x 15.99 + 10 x 18.02= 318.38 g/mol
% by weight = (MM K/MM K2CO3.10H2O ) x 100= (39.1/318.8) x 100=12.26 %
The percent composition by weight of potassium in potassium carbonate decahydrate is 13.98%
Let's represent the chemical formula of the compound as follows;
potassium carbonate decahydrate = CH₂0KO₁₃
The molecular mass of the compound can be calculated as follows:
Molecular mass of CH₂₀KO₁₃molecular mass = 12 + 20 + 39 + (16×13) = 279 g/molmass of potassium = 39 g
Therefore,
% mass of potassium = 39 / 279 × 100
% mass of potassium = 3900 / 279
% mass of potassium = 13.9784946237
% mass of potassium = 13.98 %
learn more on percentage composition here: https://brainly.com/question/3905173
What atom has the largest atomic radius barium calcium magnesium radium
Answers
Answer:
Radium
Explanation:
It has the highest atomic number so it would have more shells, making it larger than the others.
Sam and Jane have been investigating the amount of copper sulphate that can be dissolved in water at different temperatures .They added copper sulphate till it could not be dissolved any further and also measured the mass of copper. The results are below. What conclusions can you make from results?
Answers
Answer:
This question is so confusing, I'm sorry
How many formula units make up 10.2 g of magnesium chloride (MgCl2)?
Answers
Answer:
6.46×10²² formula units
Explanation:
From the question given above, the following data were obtained:
Mass of MgCl₂ = 10.2 g
Number of formula units =?
From Avogadro's hypothesis,
1 mole of MgCl₂ = 6.02×10²³ formula units
But,
1 mole of MgCl₂ = 24 + (35.5×2) = 24 + 71 = 95 g
Thus, we can say:
95 g of MgCl₂ = 6.02×10²³ formula units
Finally, we shall determine the formula units in 10.2 g MgCl₂. This can be obtained as follow:
95 g of MgCl₂ = 6.02×10²³ formula units
Therefore,
10.2 g of MgCl₂ = (10.2 × 6.02×10²³) / 95
10.2 g of MgCl₂ = 6.46×10²² formula units
Thus, 10.2 g of MgCl₂ contains 6.46×10²² formula units
How many moles of KBr are present in 1000 ml of a 0.02 M KBr solution?
1. .00002
2. 20
3. 50000
4. .02
5. 50
Answers
Answer:
4. .02
Explanation:
Hello there!
In this case, since the molarity of a solution is defined as the moles of the solute divided by the volume of the solution, we can see we are given the molarity and volume and are asked to compute moles; thus, we can solve as shown below:
[tex]M=\frac{n}{V}\\\\n=M*V[/tex]
Whereas the volume must be in liters (1 L in this case); in such a way we can plug in the volume and molarity to obtain:
[tex]n=0.02mol/L*1L\\\\n=0.02mol[/tex]
Therefore, the answer is 4. .02 .
Best regards!
What information does the percent composition of an atom in a molecule
give?
Answers
Answer:
percent composition tells that by mass
Pb(NO3)+MgI2=Mg(NO3)+PbI2 what type of reaction?
Answers
Pb(NO3) + MgI2 = Mg(NO3) + PbI2 is an example of a double-replacement reaction.
How many moles are 9.9 * 1024 molecules of methane?
Answers
Name the functional group in the
following molecule:
HSCH2CH3
A. alkane
B. amide
C. thiol
D. alkyl halide
Answers
Answer:
C. thiol
Explanation:
Answer:
it's C thiol I just took the test
hope this helps
have a good day :)
Explanation:
What is the correct shape and polarity of a water molecule
Answers
Answer:
D
Explanation:
because both H's should be positive and O is supposed to be negative.
Which unit is NOT correctly paired?
O Liters : Volume
O Formula Mass : Count
O Grams: Mass
O Molecules : Mass
Answers
Answer:
Molecules : Mass
Explanation:
The first three answer choices correctly pair a unit with what it measures. Molecules are not used to measure mass; grams are.
12
"C
What is the number of protons in this carbon atom?
ÖA 12
OB. 6
Ос.
18
OD. 24
what is the answer
Answers
Answer:
B
Explanation:
the number of protons never changes even if the atomic mass changes
Limiting Reactant
12.0 grams of sodium reacts with 5.00 grams of chlorine. What mass of sodium
chloride could be produced?
Nas) +
Cl2(g) →
NaCls)
(1)
(2)
Identify the limiting reactant.
Determine the amount of sodium chloride produced.
Answers
Answer:
(1) Cl₂ is the limiting reactant.
(2) 8.18 g
Explanation:
2Na(s) + Cl₂(g) → 2NaCl(s)First we convert the given masses of reactants into moles, using their respective molar masses:
Na ⇒ 12.0 g ÷ 23 g/mol = 0.522 mol NaCl₂ ⇒ 5.00 g ÷ 70.9 g/mol = 0.070 mol Cl₂0.070 moles of Cl₂ would react completely with (2 * 0.070) 0.14 moles of Na. There are more Na moles than that, so Na is the reactant in excess while Cl₂ is the limiting reactant.
Then we calculate how many moles of NaCl are formed, using the limiting reactant:
0.070 mol Cl₂ * [tex]\frac{2molNaCl}{1molCl_2}[/tex] = 0.14 mol NaClFinally we convert NaCl moles into grams:
0.14 mol NaCl * 58.44 g/mol = 8.18 gName the process that happens when a liquid turns into a gas.
Answers
Think about a hot summer afternoon at the beach
or a lake. How do the temperatures of the sand
and water compare?
A. The sand is hot; the water is cool.
B. The sand is hot; the water is hot.
C. The sand is cool; the water is cool.
D. The sand is cool; the water is hot.
Answers
Answer:
D
Explanation:
I say this because of this that I read. There was a study shown
"Our experiment was a success. We obtained data that answered our problem, “Which substance absorbs the most heat on a hot day? Sand, water, or sand with water?” The results showed that from the twenty-five trials: the cup of sand temperature ranged from 63-68°C, cup of water temperature ranged from 71-77°C, and the cup of sand with water temperature ranged from 66-71°C. Based on our data, our hypothesis was incorrect. We hypothesized that the sand would absorb the most heat since it is darker and less reflective than water; but from our data, water absorbed the most heat. In conclusion, sand absorbed the least amount of heat and water absorbed the most. Next time we want to cool down at the beach, we’ll know where to go!"
This was an experiment that was performed and this is the conclusion
Hope that helps
A falling ball looses its shape and bounces off the ground because it has...Immersive Reader
Kinetic energy
Potential energy
Elastic energy
Thermal energy
Answers
HELPPP PLZZ
During lunch each day, Alex and Hailey have been noticing the trashcans around the lunchroom are filling rather quickly with cans and bottles. They decide a recycling program would be beneficial for their school and the environment, so they brainstorm ways to get the program started. Before discussing their idea with the principal, they need to decide which of their plans would best solve the problem. Which of their ideas would best solve the problem with the least amount of inconvenience (disturbance) for everyone involved? A) Ask volunteers to separate recyclable materials from the trash. B) Remove all vending machines that sell plastic bottles or aluminum cans. C) Get a petition started to build a recycling center close to the school. D) Place plastic and metal recycling bins next to each lunchroom trash can
Answers
Answer:
c
Explanation:
i think it is C but idek but to me it sounds like the best answers but tell me if im wrong pls give me feedback
The ideas that would best solve the problem with the least amount of inconvenience is to place plastic and metal recycling bins next to each lunchroom trash can.
What is recycling?The term recycling has to do with the reuse of a material after it has passed through certain processes. The idea of recycling is highly beneficial to the environment.
Thus, the ideas that would best solve the problem with the least amount of inconvenience (disturbance) for everyone involved is to place plastic and metal recycling bins next to each lunchroom trash can.
Learn more about recycling:https://brainly.com/question/11861824
#SPJ2
molar mass of Mg(CO3)
Answers
Answer:
[tex]\boxed {\boxed {\sf 84.313 \ g/mol}}[/tex]
Explanation:
The molar mass is the mass per mole of an element or substance. The values for atomic mass on the Periodic Table are used as the molar mass. Look up the molar masses for the elements in the formula.
Mg: 24.305 g/molC: 12.011 g/molO: 15.999 g/molAnalyze the formula. Magnesium and carbon have no subscript, so there is only one atom of each. Oxygen has a subscript of 3, so there are 3 atoms and the mass has to be multiplied by 3.
MgCO₃= 24.305 + 12.011+ 3(15.999) MgCO₃= 24.305+12.011+47.997=84.313 g/molThe molar mass of magnesium carbonate is 84.313 grams per mole.
Calculate the molecular mass for the following: SnO2
Answers
Answer:
[tex]MM=150.71g/mol[/tex]
Explanation:
Hello there!
In this case, since the molar masses of chemical compounds allow us to understand the mass they have per mole of substance, for tin oxide, we can see it has one tin atom and two oxygen atoms; thus, for the calculation of this molar mass we multiply the atomic masses by the number of atoms and them add the results up:
[tex]MM=m_{Sn}+2m_O\\\\MM=118.71g/mol+2*16.00g/mol\\\\MM=150.71g/mol[/tex]
Best regards!
Which level is made up of organisms that break down dead organisms?
Answers
Answer:
Explanation:
decomposers
2 CH3OH + 3 02 2 CO2 + 4H2O
What is the mass of oxygen (O2) that is required to produce 579 g of carbon dioxide (CO2)?
. Your answer should have three significant figures.
Answers
Answer:
632 g
Explanation:
2CH₃OH + 3O₂ → 2CO₂ + 4H₂OFirst we convert 579 g of CO₂ into moles, using its molar mass:
579 g CO₂ ÷ 44 g/mol = 13.16 mol CO₂Then we convert CO₂ moles into O₂ moles, using the stoichiometric coefficients:
13.16 mol CO₂ * [tex]\frac{3molO_2}{2molCO_2}[/tex] = 19.74 mol O₂Finally we convert O₂ moles into grams, using its molar mass:
19.74 mol O₂ * 32 g/mol = 632 gInstruction
Active
TRY IT Writing Measurements in Scientific Notation
Choose the scientific notation that best represents the standard notation given.
6,840,000,000 m
68.4 x 108 m
6.84 x 108 m
6.84 x 10-9 m
6.84 x 109 m
0.000000000143 g
-1.43 x 1010 g
1.43 x 10-10 g
14.3 x 1010 g
14.3 x 10-10 g
COMPLETE
DONE
Answers
Answer:
D & B
Explanation:
just did it
Assume the copper was not thoroughly dried. How will the following calculations be affected?
The calculated mass of copper will be too low or too high?
The calculated moles of copper will be too low or too high?
The calculated mass of chlorine will be too low or too high?
The calculated moles of chlorine will be too low or too high?
Answers
Which pieces of information do you need to locate a particular star on a star
Answers
Answer:
You need a telescope and a pear of eyes
Explanation:
Ok so this is my opinion you will need a telescope and you will also need it to be night and need eyes of course!
Please someone help me with this!!
Answers
what is a 7 letter word that starts with f: Ancient plants and animals formed into rocks.
Answers
Answer:
Fossils?
Explanation:
During a hurricane, what effect can the ocean have on the beach?