by . Figure the density of the liquid in each beaker: The mass and volume of each liquid have been given in Table 1. Using the formula for density and a calculator, figure the density of each liquid and record it in the density column of Table 1. Round and write your answer out to the nearest hundredth. (This means you will have two numbers after the decimal point.) Don't forget to write the units!!!!!! (Hint: The formula was the answer to #2 on the front page.)​

Answer:

H₂

Explanation:

Answer:

D.) Formulas l, ll, and lV

Explanation:

Formula l, ll, and lV all have 2 oxygen atoms. Formula lll have 4 oxygen atoms and forumula V has 6 oxygen atoms.

Answer:

0.324

Explanation:

The following data were obtained from the question:

Concentration of NH3, [NH3] = 0.25 M

Concentration of H2, [H2] = 0.3 M

Concentration of N2, [N2] = 0.75 M

Equilibrium constant (Kc) =.?

The balanced equation for the reaction is given below:

2NH3 <==> 3H2 + N2

The equilibrium constant, Kc for a given reaction is the ratio of the concentration of the products raised to their coefficient to the concentration of the reactants raised to their coefficient. Thus, the equilibrium constant for the above reaction can be obtained as illustrated below:

Kc = [H2]³ [N2] / [NH3]²

Concentration of NH3, [NH3] = 0.25 M

Concentration of H2, [H2] = 0.3 M

Concentration of N2, [N2] = 0.75 M

Equilibrium constant (Kc) =.?

Kc = [H2]³ [N2] / [NH3]²

Kc = [0.3]³ × [0.75] / [0.25]²

Kc = (0.027 × 0.75) / 0.0625

Kc = 0.02025 / 0.0625

Kc = 0.324

Therefore, the equilibrium constant for the reaction is 0.324

It is incorrect because it should have a total of eight electrons with two electrons between each H and O

Lewis structure shows the form of bonds that occur in the valence electrons of an element or compound

This bonding usually occurs in covalent bonds

Valence electrons are electrons used in a chemical bond

The main group elements usually have valence electron configurations in the ns and np subshells, While the transition elements in the subshells (n-1) d and ns.

Element O has 6 valence electrons

Element H has 1 valence electron

To achieve stability, the element O needs 2 more electrons which are obtained from 2 electrons from the H element, while the H element needs 1 electron to be stable

So that a covalent bond is formed

Answer: Solids, gases, or liquids

Explanation:

Matter can undergo physical and chemical changes called Phase Changes. Substances are classified based on physical states, often referred to as the States of Matter. At room temperature and pressure the common Physical States of elements are solids, gases or liquids.

Most are solids only 11 are gases and 2 are liquids

The most common physical state of elements in the periodic table is Solids as there are about 84 elements which exists as solids at room temperature and pressure in the periodic table

Elements in the periodic table can exist as one of the prominent physical states at room temperature and pressure.

These physical state may be;

These elements are Hydrogen, Helium, Nitrogen, Oxygen, and the other Noble gases.

Read more:

https://brainly.com/question/21029213

Answer:

Cookies N Cream

Explanation:

Its The

Answer:

Mineral acids are very important to chemical procedures. An organic acid is an organic compound with acidic properties. ... Generally, organic acids are weak acids and do not dissociate completely in water, whereas the strong mineral acids do.

Answer:

Organic Acids:

Mineral Acids:

Answer:

It sould be 250 grams

Explanation:

It is given that, 5 millimeter sample has the mass of 12.5 grams. Then, 100 millimeter sample have a mass of  250 g.

Mass of a substance is a physical quantity that describes the total amount of the substance. Mass is an extensive property since it depends on the change in amount or quantity of the substance.

The SI unit of mass is grams (g). Other units are kilograms, milligrams , pounds etc. Mass is of small substance is expressed in grams and that bigger things are usually expressed in kilograms.

Given that mass of 5 ml sample = 12.5 grams

then mass of 1 ml = 12.5/5 = 2.5 g

then mass of 100 ml = 2.5 × 100 = 250 grams.

Therefore, the mass of 100 ml of the sample is 250 g.

Find more on mass:

https://brainly.com/question/19694949

#SPJ2

Answer:

Explanation:

In general, metals will lose electrons to become a positive cation and nonmetals will gain electrons to become a negative anion. Hydrogen is an exception, as it will usually lose its electron. Metalloids and some metals can be can lose or gain electrons.

Answer: 255 pm

Explanation: Hope this helps!

Answer:

Key Points

Viral replication involves six steps: attachment, penetration, uncoating, replication, assembly, and release.

During attachment and penetration, the virus attaches itself to a host cell and injects its genetic material into it.

Answer:

The empty cup

Explanation:

Got it right on the test

Answer:

• Copper chloride

• Copper (II) chloride

• Iron (II) sulfide

• Iron (III) sulfide

Answer:

It is secondary succession.

Explanation:

primary succession only occurs in areas where there was no previous ecosystem

In the production of maple forest over the 1,000 years period, there has been the presence of the lake. Thus the production in the lake has been the secondary succession.

The primary and secondary succession has been the development process in the ecosystem. The ecosystem development can be taken place when there has been no previous vegetation, or when there has been the available ecosystem.

The primary succession can result when there has been no available previous ecosystem. The secondary succession can take place when there has been a previously existing ecosystem.

In the production of maple forest over the 1,000 years period, there has been the presence of the lake. Thus the production in the lake has been the secondary succession.

For more information about succession, refer to the link:

https://brainly.com/question/1151386

Answer: 1 C4H6O3 + 1 H2O -> 2 C2H4O2

Explanation:

LEFT HAND SIDE:

C= 4

H=8

O= 4

RIGHT HAND SIDE:

C= 2

H= 4

O= 2

You want the left side to be equal to the right side.

We can multiply each atomic element by 2, to get C4H8O4.

Answer:

46.943 million km

Explanation:

From an average distance of 36 million miles (58 million kilometers), Mercury is 0.4 astronomical units away from the Sun.

From an average distance of 36 million miles (58 million kilometres), Mercury is 0.4 astronomical units away from the Sun.

(I hope this helped ^^)

Answer:

It would be 3.1063937724731447 moles.

Hope this helps :)

Answer:

d. The density of a substance is always the same, regardless of temperature.

Explanation:

Density is a characteristic property of water and defined as the mass per unit volume.

The density of a substance always remains the same at the same temperature regardless of the size of the sample. The density of the sample changes with temperature and pressure. for example : The density of a substance increases with a decrease in temperature as the volume increases.

Hence, the statement about density is not true is " d. The density of a substance is always the same, regardless of temperature."

Answer:

44894

Explanation:

Answer:

Answer:

sulfur

Explanation:

From the given lists of elements, the one with the most electronegativity is Sulfur.

  Electronegativity is of an element is a property that combines the ability of its atom to lose and gain electrons.

It is a measure of the relative tendency with which the atoms of the element attract valence electrons in a chemical bond.

Using the Pauling's electronegative table of elements;

   Here are electronegativity values of the given elements;

selenium                 2.4

arsenic                    2.0

phosphorus            2.1

sulfur                      2.5

We see that the value of sulfur is the highest.

Answer:

polar covalent

Explanation:

If they do not equally share the electron then it is polar and covalent bonds share electrons

Answer:

All of the above

Explanation:

I know about the first two choices but not so much about the last one

Answer:

2 Hydrogen atoms, 1 Sulfur atom and 4 oxygen atoms.

Explanation:

H has a 2 next to it. S has no number assigned to it meaning it represents 1 atom. Lastly, O has a 4 next to it.

Hope this helps!!

Answer:

7

Explanation:

2 hydrogen atoms. 1 Sulphur atom. And 4 Oxygen atoms.

The superscript 2 and 4 show how many of the element are there.

Answer:

Thank you ☺️

Answer:

V = 21.2 cm³

Explanation:

Given data:

Diameter of block = 3.0 cm

Volume of block = ?

Solution:

Formula:

V = 2πr³

First of all we will calculate the radius from diameter.

r = d/2

r = 3.0 cm/2

r = 1.5cm

V = 2(22/7) (1.5cm)³

V = 2(3.14) (3.375cm³)

V = 21.2 cm³