Answer:
11 molecules of CH4.
23 atoms of C is the leftover.
Explanation:
Hello!
In this case, for the formation of methane:
[tex]C+2H_2\rightarrow CH_4[/tex]
We can see there is an excess of carbon based on their stoichiometry, because the needed amount of hydrogen gas molecules would be:
[tex]molecules _{H_2}=34atomC*\frac{2molec\ H_2}{1atomC} =68molec\ H_2[/tex]
Thus, the formed molecules of methane are computed below:
[tex]molec\ CH_4=22molec\ H_2 *\frac{1molec\ CH_4}{2molmolec\ H_2} \\\\molec\ CH_4=11molec\ CH_4[/tex]
In such a way, the leftover of carbon atoms are:
[tex]atoms \ C^{left over}=34-22molec\ H_2*\frac{1atoms C}{2molec\ H_2} \\\\atoms \ C^{left over}=23 atoms C[/tex]
Best regards!
How many molecules are in 38.4 moles of NF3?
Answer:3
Explanation:
I added and substituted for the garlic
8. Water behind a dam, a moving car, and electricity moving in a circuit all are examples of
energy because they
a. Help accomplish a job
b. Can cause change
C. Are expensive to create
d. Come from fossil fuels
Answer:
a. Help accomplish a job
Explanation:
Energy is defined as the ability to do work. It is the ability to get a job done.
Where energy is deficient, no job or work can be done.
In a water behind a dam, potential energy is stored. Potential energy is due to the position of a body. A moving car has kinetic energy which the energy due the motion of a body. Electrical energy is used to carry the currents in a circuit round about.What is the name of the compound with formula P3O10?
Answer:
The compound of the formula is Sodium triphosphate.
Explanation:
0.446 g of hydrogen gas fills a 5.0 L bag determine the density of hydrogen
The density of hydrogen : ρ = 0.0892 g/L
Further explanationGiven
mass of Hydrogen : 0.446 g
Volume = 5 L
Required
The density
Solution
Density is a quantity derived from the mass and volume
Density is the ratio of mass per unit volume
The unit of density can be expressed in g/cm³, kg/m³, or g/L
Density formula:
[tex]\large {\boxed {\bold {\rho ~ = ~ \frac {m} {V}}}}[/tex]
Input the value :
ρ = m : V
ρ = 0.446 g : 5 L
ρ = 0.0892 g/L
The chemical formula for methanol is: Calculate the molar mass of methanol. Round your answer to decimal places.
Answer:
CH3OH (Methanol)MM = 12 + 8 + 16 = 36u
An empty Erlenmeyer flask weights 241.3 g. When filled with water (d = 1.00 g cmଷ ⁄ ), the flask and its contents weight 489.1 g. What is the flask’s volume? What is the mass of the flask when filled with chloroform (d = 1.48 g cmଷ ⁄ )?
Answer:
608 g
Explanation:
Mass of flask + contents = 489.1 g
Mass of flask = 241.3 g.
Mass of water = 489.1 - 241.3 = 247.8 g
Density of water = 1.0 g/cm^3
volume of water = 247.8 g/1.0 g/cm^3
Volume = 247.8 cm^3
But
Volume of flask = volume of water
Volume of flask = 247.8 cm^3
volume of chloroform = volume of flask
mass of chloroform = 1.48 g/cm^3× 247.8 cm^3
Mass of flask + chloroform = 366.7 g + 241.3 = 608 g
Many organisms on Earth exhibit similar ____________.
Question 1 options:
time
single-celled
characteristics
nonliving
Answer:
Characteristics
Explanation:
hope this helps
The strongest spring tide occurs when?
Answer:
the sun and moon are aligned with the earth.
Answer:
uhhh first or third quarter
Explanation:
PLEASE HELP! Due in 1 minute chemistry lewis structure.
Am i correct?
This image of a baby was produced using ultrasound.
Which option is the best model of how the image was made?
O An X-Ray
O An echo
O A convex lens
O A turbine
Answer:
im pretty sure its "An echo"
Explanation:
Answer: An echo
Explanation:
it's very much correct
Which of the following is true of ionic bonds?
Moving electrons become delocalized between the atoms creating the
ionic bond
Electrostatic attraction results in the arrangement of charged atoms in a
regular, geometric structure called a crystal lattice.
Transferring of valence electrons creates the bond
The bond is created by oppositely charged metal and nonmetal atoms
Sharing Valence electrons between nonmetal atoms creates the bond
Answer:
D: The bond is created by oppositely charged metal and nonmetal atoms.
Explanation:
An ionic metal basically involves a metal and a nonmetal in bonding. A metal is a cation with a + charge and a nonmetal is a anion with a - charge. I will give you an example. Magnesium Chloride is a ionic bond. This is because Magnesium is a metal with a +2 charge(so it is a cation). Chloride or Chlorine is a nonmetal because it has a -1 charge.(so it is a anion). The chemical formula for magnesium chloride is MgCl2.
Hope my answer helped! Have a great day.
What is conclusive evidence that mixing sugar in water is a physical change
Explanation:
1) their is no formation of new substance
2) the reaction can be reverse i.e if we heat sugar solution it we give us sugar and water.
For all seawater problems, assume the salinity is 3.5%
If you have a 2000 gram sample of seawater, how many grams of pure water are there?
0.035 x 2000) = x, 2000 - x = pure water
Answer to the nearest WHOLE number.
Answer:
1930g
Explanation:
We have been given that the salinity of sea water is 3.5%;
Now the mass of sea water sample is 2000g
So, problem here is to find the quantity of pure water in the sample = ?
Solution:
Let us find the quantity of the salt in the sample;
Salt content = 3.5% x 2000 = 70g
Amount of pure water = 2000 - 70 = 1930g
How do you draw a branched carbon chain for trimethylbutane?
Answer:
I think this is how you draw it, but I'm not entirely sure.
Explanation:
Screenshot below:
Which of the following is the metallic ion in sodium fluoride? 1. Na 1- 2. Na1 + 3. F 2- 4. F 2+
Answer:
2. Na1 +
Explanation:
The formular for sodium fluoride is; NaF
The metal in sodium flouride is sodium.
Sodium belongs to group 1, hence would lose one electron when forming ions.
This is represented as;
Na+
Please help me thanks so much....I’ll mark you?!?!:)))) ( 15 points)
Answer:
all of the above
Explanation:
Nitrogen-13 has a half-life of about 10 minutes. How much of a 320g sample of N-13 would remain after 40 minutes?
Answer:
The half-life of a radioisotope describes the amount of time it takes for said isotope to decay to one-half the original amount present in the sample.
Nitrogen-13, because it has a half-life of ten minutes, will experience two half-lives over the course of the twenty minute period. This means that 25% of the isotope will remain after this.
0.25 x 128mg = 32mg
32mg of Nitrogen-13 will remain after 20 minutes.
26. A pathogen is any organism that causes a disease. Which of the following is an example of a pathogen that
infects humans?
A.parasite
B.plasmid
C.plant cell
D.plasma membrane
Answer:
A.parasite
Explanation:
which of the following pairs of elements is most likely to form an ionic bond
a( phosphorus and bromine
b(calcium and bromine
c( carbon and chlorine
d(silicon and oxygen
Answer:
it is calcium and bromine
Explanation:
this is because they are both ionic compounds
(Please explain the answer. Thank you!)
A chemist needs 2.00 g of a liquid compound, which has a density of 0.718 g/mL. If the
compound costs $5.67 per mL, how much will a 2.00 gram sample cost?
Sample cost = $15.796
Further explanationGiven
Mass = 2 g
Density = 0.718 g/ml
Cost = $5.67 per mL
Required
Cost
Solution
The density : the ratio of mass and volume
Can be formulated :
Density (ρ) = m : V
The volume of the liquid :
V = m : ρ
V = 2 g : 0.718 g/ml
V = 2.786 ml
Sample cost :
= 2.786 ml x $5.67/ml
= $15.796
Over long periods of time, a series of processes continuously change rocks from one type into another. This is called the rock cycle. A combination of subsurface and surface processes are responsible for the recycling of rocks in the geosphere.(that was the story)
What two processes are responsible for changing metamorphic and igneous rock into sedimentary rock?(this is the question)
A) intrusive and extrusive
B) weathering and erosion
C) subduction and sea floor spreading
D) heat and pressure
Answer:
B) weathering and erosion
Explanation:
The two processes responsible for changing metamorphic and igneous rocks into sedimentary rocks is weathering and erosion.
Weathering is the defined as the physical disintegration and chemical decomposition of rocks to form sediments and soils.
Erosion is the removal of weathered materials from the surface of the earth.
The process of erosion and weathering serves to convert igneous and metamorphic rocks into sediments by which a sedimentary rock is formed.
Answer: The rock cycle
Explanation: Well its kinda obious that it is the rock cycle because the question says it changes countinuously to other rocks so yeah rock cycle is answer to question.
Why is the time series useful as a management tool?
A) It estimates the probability of extinction.
B) It estimates the harvested numbers.
C) lt monitors a population's age structure.
D) It designates wildlife refuge areas.
Answer:
A)
Explanation:
It estimates the probability of extinction.
how many grams og gas must be relased from a 45.2 L sample of N2 at STP to reduce the volume to 45.0 L at stop
Answer:54,6
Explanation:
Answer:
yes it is 54,6
Explanation:
54,6 you ar correct you did a graet job
Inspiration for new types of synthetic materials often comes from observations of…
Answer and Explanation:
Inspiration for new types of synthetic materials come from natural materials where a derivative is needed to be used in situations where properties of a natural material are adjusted. Inspirations for new types of synthetic materials can also come from current synthetic materials that create toxins, and new ones are created with the same properties but with less harmful downsides.
Which atorn was used to determine the amount of particles in a mole?
Answer:
carbon atom is used to determine the amt of particles in a mole
why are cell wall chloroplast and vacuole found in plant cell only while centriole is for animal cell only?
Answer:
The cell wall and chloroplasts are essential for autotrophic processes, basically allowing plant life to thrive off of self-made nutrients/food. This is why they are only in plant cells.
Centriole:Anatomically, animal cells have them and plant cells don't have them. Centrioles direct the movement of chromosomes during cell division, but plant cells don't need this since they use photosynthesis.
Explanation:
Which of the following is not a natural change to the envlronment? drought , flood, disease ranching
Answer:
Disease ranching
Explanation:
Floods and Droughts are caused by the enviorment. Diseases are but a product and don't affect the enviorment.
Answer:
disease ranching is not a natural change to the environment .
Explanation:
This all happen because of human activities
please fast!!!!!!!!!!!!!!!!!!!!!!
Answer:
1 g/mL.
Explanation:
From the question given above, the following data were obtained:
Volume = 100 mL
Mass = 100 g
Density =?
Density of a substance is simply defined as the mass of the substance per unit volume of the substance. The density can be expressed mathematically as:
Density (D) = mass (m) / volume (V)
D = m / V
With the above formula, we can obtain the density of the liquid as follow:
Volume (V) = 100 mL
Mass (m) = 100 g
Density (D) =?
D = m / V
D = 100 / 100
D = 1 g/mL
Thus, the density of the liquid is 1 g/mL
Tonic bonding is the result of electron transfer.
Lose electrons and become positive ions. While,
Gain electrons and become negative ions.
gain
Write your two answers with a comma between them like: dogs, cats.
Answer:
metals, non-metals
Explanation:
Ionic bonding results from electron transfer. To form this bond type, metals lose electrons and becomes positive ions. While non-metals gain electrons to become negatively charged.
Ionic bond forms between a very less electronegative substance and one with with a higher one. The two ions formed attracts one another with an electrostatic force. This electrostatic force is the ionic bonding that holds the atoms together.I need help as fast as possible