1. Write a brief summary of the main steps you took in the procedure and the point of each step. (For example, why did you have to make sure there was a total of 50 items for each trial, what was the purpose of having 50 items instead of fewer, and so on?) Be sure to include any adjustments you may have made to the procedure and why you made them. (5 points)

Answer:

true

Explanation:  pull in relatively cool water to cool their machinery and let the relatively warm water flow back into the river or lake or sea. ... Water on hot paved surfaces gets hot, then runs off into nearby bodies of water, raising the water temperature

Answer:

True

Explanation:

Heat is classified as is classified as a water pollutant when it is caused by heated industrial effluents or from anthropogenic (human) alterations of stream bank vegetation that increase the water system temperatures due to solar radiation.

Hope that helps

Answer:

D) 100*C

Explanation:

Answer:

A. 0°C

Explanation:

El agua se evapora a los 0 grados

Answer:

A)sex cells

Explanation:

it’s the production of gametes, or sperm and eggs

Answer:

Copper(i) nitrate

Explanation:

That is the correct name.

Answer:

Molecular Formula

Explanation:

it is in a liquid state

Explanation:

Yes. Stars use fusion to create nuclear energy, which is what makes them "alive". The older they are, the "bigger" the element in them is. Hydrogen turns into Helium, and when hydrogen is used up, the helium starts fusing into bigger elements. it stops at iron however. Once stars start fusing silicon to iron, it is doomed because it takes more energy than it gives off.

Answer:

shear adhesion

Explanation:

edge

Shear adhesion sticks best when it is pulled down parallel to the surface.

Shear adhesion is defined as the ability  of tape due to which it resists the static forces which are applied in same plane as in backing.It is usually expressed in terms of time required  by a given weight for an amount of tape to become loose  from a vertical plane.

Molecular weight between two entanglements is the controlling factor of shear adhesion. Shear adhesion is affected by the following parameters which areas follows:

1)Tg of adhesive - Shear adhesion increases as Tg rises up to a certain temperature which is less than the room temperature.

2)  Tan delta  minimum value of adhesive- It is found that shear adhesion improves by an increase in tan delta minimum value.

3)Adhesive polarity- It is an important factor which affects adhesion  such as tack,peel and shear.Adhesion performances are improved by introducing polar ingredients in the formulation.

Learn more about shear adhesion,here:

https://brainly.com/question/13385447

#SPJ6

Answer:

A. Has only one kind of atom

Explanation:

All forms of matter are composed of elements.

An element is a substance which cannot be broken down into simpler units or converted into other substances by ordinary chemical reactions. Each element is composed of only one kind of atoms which are unique to each element. There are three fundamental sub-particles present in atoms of elements; these are: protons, electrons and neutrons. An atom of an element differs from an atom of another element by its atomic number. The atomic number of an element is the number of protons present in the nucleus of the atom of that element. For example, hydrogen atoms has an atomic number of 1, while sodium atoms has an atomic umber of 11.

Atoms of the same element or different elements may combine together to form the molecules of a substance. For example, a molecule of hydrogen gas is made up of two atoms of hydrogen whereas a molecule of water is composed of two atoms of hydrogen and an atom of oxygen.

Elements can exist in any of the three physical states: solids, liquids or gases. For example, hydrogen exists as gas, mercury as a liquid, while gold exists as a solid.

CaCO3(s) + 2HCl(aq) → CaCl2(aq) + H2O(l) + CO2(g)

Answer:

2 Cu2O + C = 4 Cu + CO2

Explanation:

CU2O has 2 coefficient

C has 1 coefficient

Cu has 4 coefficient

CO2 has 1 coefficient

Balance Equation 2 Cu2O + C = 4 Cu + CO2

Answer:

2CU2O + C -----> 2Cu + CO2

Explanation:

2 is added in reactants to balance oxygen O on both sides and 2 before Cu is added in products to balance Cu on both sides.

Answer:

415.401g

Explanation:

1 mol of CaCl = 75.5g

5.502mol of CaCl = xg

so 5.502 × 75.5 = 415.401g

Answer:

I'm pretty sure that liquid moves by vibration

Explanation:

I asked my cousin

Answer:

sodium example salt and soy sauce

potassium example meat milk fresh fruits

Answer:

Genes on the X chromosome are said to be X-linked. X-linked genes have distinctive inheritance patterns because they are present in different numbers in females (XX) and males (XY). X-linked human genetic disorders are much more common in males than in females due to the X-linked inheritance pattern.

Explanation:

Answer:

CLIMB A MOUTAIN

Explanation:

B

The carbon and silicon have in common that they belong to the same column (family), therefore they have the same number of total electrons. So, option B is correct.

Carbon's closest analogue is silicon. Silicon and carbon are both tetravalent atoms that primarily form covalent (non-ionic) compounds. However, aside from the fact that both elements "can form four covalent bonds," there is surprisingly little in common between them.

Carbon has an atomic number of 6 and an electronic configuration of 2, 4. Silicon has an atomic number of 14 and an electronic configuration of 2, 8, 4. Because both elements have the same number of valence electrons, they are classified as being in the same group.

Thus, option B is correct.

To learn more about the carbon and silicon, follow the link;

https://brainly.com/question/1966406

#SPJ1

Answer:

Calcium carbonate is a molecule that contains one atom of calcium, one atom of carbon, and three atoms of oxygen.

:)

Answer:

i thinks its one carbon atom

Explanation:

Answer:

D

Explanation:

Offspring receive genes from both parents, they don't always have a recessive or dominant train but if they do have a dominant trait, it will always show while the recessive will only show if there is no dominant trait. For example: DD, Dr, and rr (D= dominant r = recessive)

Answer:D

Explanation:

i did this one too and it’s right

Answer:

Here... Since there is excess HCl, you know the Zinc will be the limiting reagent.  I was able to create the reaction equation based on the info you gave: Z + 2HCl ----> ZCl2 +2H.  Now, in order to find the theoretical yield of ZCl, you need to convert Zinc from grams to moles.  Do this by dividing by its molar mass (65.38), thus: 3.68 (g) / 65.38 (g/mol) = 0.056286... moles.  

Now, using the balanced equation we made earlier, we see that 1 mole of Zinc creates 1 mole of ZCl2.  Thus our ratio is 1:1.  This makes the next step easy.  Since it is 1:1, we multiply the number of moles we have of Zinc (0.056286...) by the number of moles it will create of ZCl (1).  (0.056286)(1) = 0.056286 moles ZCl.  Now convert this to grams by multiplying by its molar mass (136.28) and you get 7.67 grams.  This is your theoretical yield.  The percent yield is found by dividing the actual amount obtained (7.12 g.) by the theoretical yield (7.67 g.) then multiply that by 100%.   When this is done, your Percent Yield is about 92.8%

Answer:

Eurkaryote... sorry if i wrong

Explanation:

Answer:

8 electrons (e-)

Explanation:

In the atom of every elements, there are three sub-atomic particles namely: protons, electrons, and neutrons. The protons are the positively charged particles, the electrons are negatively charged while the neutrons are neutrally charged.

In an uncharged or neutral atom i.e. charge 0, the number of protons is always equal to the number of electrons because they cancel each other out. When a difference occurs in the number of these particles, the atom becomes charged i.e. an ion. According to this question, oxygen atom (O) contains 8 positively charged protons, this means that it also contains 8 negatively charged electrons in its atom.

Answer:

124g  

Explanation:

The concept stoichiometry is used here to determine the mass of Na₂O. The grams of Na₂O required to produce 1.60 x 10² grams of NaOH is  124 g.

The stoichiometry is an important concept of chemistry which help us to use the balanced chemical equation to calculate the amounts of reactants and products. The stoichiometric coefficient is the number of molecules that can participate in the reaction.

The balanced equation is:

Na₂O + H₂O → 2NaOH

1 mole of Na₂O is required to react with 1 mole of  H₂O to give 2 moles of NaOH.

62 g of Na₂O produces 80 g of NaOH.

1 g of NaOH is produced from 62/80 g of Na₂O .

1.6 × 10² g of NaOH will require 62 × 1.6 × 10² g / 80 g of Na₂O = 124 g Na₂O

Thus the grams of Na₂O required to produce 1.6 × 10² g of NaOH is 124 g.

To know more about stoichiometry, visit;

https://brainly.com/question/29775083

#SPJ7

Answer:

The effects of supercritical CO2 (SC-CO2) on the microbiological, sensory (taste, odour, and colour), nutritional (vitamin C content), and physical (cloud, total acidity, pH, and °Brix) qualities of orange juice were studied. The CO2 treatment was performed in a 1 litre capacity double-walled reactor equipped with a magnetic stirring system. Freshly extracted orange juice was treated with supercritical CO2, pasteurised at 90°C, or left untreated. There were no significant differences in the sensory attributes and physical qualities between the CO2 treated juice and freshly extracted juice. The CO2 treated juice retained 88% of its vitamin C, while the pasteurised juice was notably different from the fresh juice and preserved only 57% of its vitamin C content. After 8 weeks of storage at 4°C, there was no microbial growth in the CO2 treated juice.

Answer:

epic

Explanation:

hakuna matata

Answer:

The answer is 1:1

Explanation: